Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Tool post diameter

Posts

Tool post diameter

#1

Tool post diameter

Clyde Collier

>Can someone tell me if the tool post diameter for the Delta 46-460 midi-lathe is 5/8 or 3/4 inches?

Thanks,

Clyde

Re: Tool post diameter

#2

Re: Tool post diameter

john lucas

>I'm pretty sure it's 5/8" but I only had my calibrated eye with me when I looked at it. I remember commenting that I wish they had made it 3/4. Hopefully someone who has one will comment. I looked up the specs and they don't tell you.

Re: Tool post diameter

#3

Re: Tool post diameter

Clyde Collier

>Thanks John, I thought it was 5/8 also. I know that Keith Z. recently bought one and can confirm.

Re: Tool post diameter

#4

Re: Tool post diameter

john lucas

>When they came to our club to ask for help in designing a new lathe, I told them the weakpoint on most minis is the tool rest. The post is too small the cast tool rest in that size break. They did apparently listen to some of what I said but this one went over their head.

Re: Tool post diameter

#5

Re: Tool post diameter

keith zimmerman, Normal, IL

>Mine is 5/8", same as my Jet Mini.

keithz

Re: Tool post diameter

#6

Re: Tool post diameter

Clyde Collier

>Thanks John and Keith. That is what I needed to know to make some additionjal tool rests for the lathe I have on order.

Re: Tool post diameter

#7

Re: Tool post diameter Now 3/4"

Dave Anderson (PacNW)

>after breaking the tool post on my jet mini twice in a week. The banjo went to the drill press where it met a sharp 3/4' reamer. I now use 3/4' tool posts.

Re: Tool post diameter

#8

Re: Tool post diameter Now 3/4"

Clyde Collier

>I was looking at the banjo on my Jet mini and wondered if it could be reamed out to 3/4 and not weaken the casting. I think that you have answered that question for me.