Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

delta saw

Posts

delta saw

#1

delta saw

jimtex

>hi ya'll! recently i went to start my 14" delta band saw and it failed to operate. it will hum for a few seconds then trip the gfci. it is not bound up as the wheels turn freely. anybody got any ideas?? thanks, jim

Re: delta saw

#2

Re: delta saw

JohnKyler

>Sounds like a starting capacitor.

I would guess you could give it a good spin with the switch on (before the GFI trips) and it likely will run?

John

Re: delta saw

#3

Re: delta saw

Ken Oakley-Sunny St. Cloud, Fla.

>I put my money on Johns answer.

Re: delta saw

#4

Centrifugal switch ?

Doc Green

>I have a Sears radial arm saw (1985 model)that periodically shows the same symptoms: hum but not start. The problem is dirty contacts in the centrifugal switch. I take the switch apart, clean the contacts, and I'm back in business.

I'm not familiar with the Delta bandsaw. It may not even have a centrifugal switch. Do you hear a click as it slows to a stop? If you do, then it does have a switch. That's the first thing I would check. Good luck. ~Doc

Re: delta saw

#5

Re: delta saw

Texian

>Could be both the switch and the capacitor. Had same problem with Delta table saw.

Re: delta saw

#6

Steve Kubien

gerbil

Steve Kubien

>You need a new gerbil.

Steve

-sorry, suffering with a fever and possibly over-medicated

Re: delta saw

#7

Dennis in Southern Oregon

Re: delta saw

Dennis in Southern Oregon

>John, did you mean the circuit breaker or the GFI breaker? The GFI breaker should not trip unless there leakage current to the ground return. If that is the case, you need to isolate and fix that problem.

Dennis