Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Help, newbie turning question.

Posts

Help, newbie turning question.

#1

Help, newbie turning question.

Brian in Brighton

>Help. I started turning a small urn to hold me kitties ashes last night. I had some problems. The urn is about 3 inch dia x 3 inch high.

My experience is limited. I have a Delta variable speed floor stand lathe.

I got the side done fine between centers.

Took the part off the lathe and put on a face plate with double face carpet tape. Tried to turn the end of it and it came off about 12 times, no matter how slightly I touched the tool to the base. How do you hold it on with tape?

I put the part in the drill press and drill a 2.125 hole in it. Now I turned the face plate to make a jam chuck out of it. The same thing happened when I tried to turn the base. It held better, but not quite good enough.

Does anyone have a you tube video that they would recommend, or any articles that have pointers? I'm trying to get it done by the end of the week.

Thanks,

Brian in Brighton

Re: Help, newbie turning question.

#2

Dick Hines

Re: Help, newbie turning question.

Dick Hines

>I take it you don't have a chuck. Take the face plate that came with your lathe and screw it to the bottom of the urn. You will most likely have to true up the out side again. After you have it trued up you can hollow out the inside.

When you have finished hollowing then you can part the base off nice and clean.

Re: Help, newbie turning question.

#3

Re: Help, newbie turning question.

Brian in Brighton

>Ohhhh. I do not have a chuck, but have thought about getting one.

Brian in Brighton

Re: Help, newbie turning question.

#4

Re: Help, newbie turning question. *LINK*

john lucas

>I am assuming you didn't leave a tenon on the bottom. I would put a waste block on the faceplate. Turn a shallow hole to exactly fit the bottom of the vessel. this hole is only used for alignment so it can be really shallow. Put some glue in the hole and glue it in using the tailstock in the top of the vessel for more alignment. let the glue dry and hollow the vessel. Then use a parting tool to cut away the waste block down to the vessel sides and then use the same tool to cut away the bottom. You will have to sand the bottom unless you have a jam chuck to fit the hole you are hollowing through so you can turn the bottom.

Another possibility is what we call a doughnut chuck. This is a waste block on the faceplate with a shallow hole for the bottom of the vessel. The wasteblock is large enough to drill 3 holes for long bolts on the outer edge. Then you place ring of wood shaped like a flat doughnut over the upper thick part of the vessel. This has matching holes for the bolts. Bolt these parts together with the vessel inbetween and then you can hollow. There is a photo of a doughnut chuck on our club website under the tips section. Click on the methods for reverse turning a bowl and you will find it. It's in the link below.


http://www.cumberlandwoodturners.com/htm/tips.htm

Re: Help, newbie turning question.

#5

Steve Kubien

Re: Help, newbie turning question.

Steve Kubien

>Without a chuck and using the piece you have already started, I would go John's route. If you are willing/able to start over, I would round a piece between centres and mount it on a glue block (attached to a faceplate) using thick C. Turn the outside using the tailstock as long as is practical and then hollow. Part it off the glue block and clean up the bottom with the help of a jam chuck.