Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Rotary detail carvers

Posts

Rotary detail carvers

#1

Rotary detail carvers

Paul Zerjay

>Is there any kind of special maintenance a guy should do to his detail handpiece? Mine's not got a terrible amount of hours on it, and it seems to be getting hotter than it used to. I blow the dust out occasionally, but that's about it. Is there some sort of lube for these tools?

Re: Rotary detail carvers

#2

Re: Rotary detail carvers

mfoster

>It depends on what handpiece it is, but the answer is yes. High speed handpieces (dental drills) need a thinner lube (usually a spray) and this should be done relatively regularly (1x/day). Other handpieces (like those used for foredoms) need lubed with a little thicker oil, and usually not as frequently. It would be worth it to find your manufacturers manual as each handpiece and company is a little different. Warm is not good.

Mike

Re: Rotary detail carvers

#3

Re: Rotary detail carvers

Paul Zerjay

>hmmm...All my book talks about is shaft lube. Mastercarver

Re: Rotary detail carvers

#4

Re: Rotary detail carvers

Don Evans

>Paul I also have a Mastercarver and it is top of line unit. There are at least 4 main type handpieces that you can get for it and you don't say which one?

I'm guessing due to your wording you are really asking about the flexshaft which is much more flexible than say a dremel. There is a tendency if not careful due to it's flexibility to over flex it. You should clean the inner cable and lube it with the grease made for it. As far as I know it is the same grease as "Foredom" which you can get from Woodcarvers Supply and Foredom.com.

I have every handpiece that Woodcarvers carries except the 90 deg and there is no maintenance for them that I see. The bearings are lifetime lubed.

If you find this to be incorrect, please email me about it.

Don

Re: Rotary detail carvers

#5

Re: Rotary detail carvers

Don Evans

>Forgot, there is a video on how to do the flexshaft on Foredom site. I recommend looking at it as simple as it may look to do, I learned a couple of things watching it.

Don