Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Bowl rim enhancements

Posts

Bowl rim enhancements

#1

Bowl rim enhancements

Paul Zerjay

>Keith Rowley"s book, Woodturning... A Foundation Course, has a short section on router enhancements, but it's mostly spindle work. It has a good picture of a carriage for a router. I am looking for pictures of carriages for the router, as well as the sled. I made one years ago for a jet 14-42, (I have since upgraded to a larger lathe). It worked quite well, although it was dedicated to spindle type work. I want to build one that will allow me to turn it 90 degrees and work faceplate style as well. I believe I know what I want, but would like to see some pics of others' jigs, in that I may incorporate your ideas into my new jig. Any pictures, or links would be greatly appreciated.

Re: Bowl rim enhancements

#2

Re: Bowl rim enhancements *LINK*

john lucas

>Paul I've had 2 articles on using router sled for turning enhancement in Woodturning Design. One was on routing on a box and one was a routed Xmas ornament. It's a pretty simple process. Build a platform that either attaches to the bed or attaches to the banjo. This supports the router. Build some sort of holder to hold the router, flex shaft handpiece, dremel, or Die Grinder. This rides on the router platform.

I use an index wheel to divide the router cuts but you can do it by eye or make pencil marks or whatever works.

Below is the tips section of our club website. I have a PDF of my fluting jig. This one sits on the bed of the lathe but I also use platforms that have a 1" steel base to fit in my lathe banjo.


http://www.cumberlandwoodturners.com/htm/tips.htm

Re: Bowl rim enhancements

#3

Re: Bowl rim enhancements

Paul Zerjay

>Thanks John. That's not a bad design. I'm using a laminate trimmer type router and I like your clamping method. Threaded inserts? I made my previous one where the sled was "trapped" under two runners for the in and out movement. It also slid along the bed on a plywood sled with a runner in between the two rails. Thanks for the pic.

Re: Bowl rim enhancements

#4

Re: Bowl rim enhancements *LINK*

Dick Coers

>I saw a link to this page a couple days ago. Maybe not USA friendly for a purchase, but it sure is a nice rig.


Avisera Compound Slide

Re: Bowl rim enhancements

#5

Re: Bowl rim enhancements

Skip Beardsley------WebKitFormBoundarylsHY4+4w161B

>If I am lucky, there may be a picture of the router jig I use for doing inlays on the rims of bowls. This one is on my mini jet and I also have on for my Delta 1642.

It is pretty straight forward construction. There is a piece glued to the bottom which sits between the ways and it is clamped in place with a knob at the rear.

Both the front and rear of the sliding portion are captured in order to keep it in place.

Hope this helps in your search for bowl rim enhancements. I will try to post a picture of the latest one which I have done.

Skip


img

Re: Bowl rim enhancements

#6

Re: Bowl rim enhancements 

Skip Beardsley------WebKitFormBoundarylsHY4+4w161B

>


img

Re: Bowl rim enhancements

#7

Re: Bowl rim enhancements

Paul Zerjay

>Thanks Skip. I know there is really not much to 'em, but I was hoping to get some ideas that I have not thought of. That's the same router that I use. Thanks for the pic