Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

My Second favorite home made calipers.

Posts

My Second favorite home made calipers.

#1

My Second favorite home made calipers.

Barry Irby

>These are my second favorite home made calipers. (I took my favorite set to a demo I did and they ran away from home, they were the same, but smaller)

They are made of plastic about 3/16" thick. The pivot is a tee nut, because that is what I had in the drawer. Any bolt will work.

The two sides are identical and cut at the same time. The line on the handle is the closed position. You could scribe a scale on them if it suits you. When they are closed the handles line up with each other and this gives a very tactile fell to them. Your fingertips will tell you very quickly if the thickness changes, even very subtle bulges.

I also like the fact that you can reach in between the Plates on Cole jaws and check the thickness as you turn the outside and you can check the thickness of the bottom as you cut the chuck foot off.

The critical point here is that the distance between the pivot and the tips is the same as the handle length, thus the reading is the same on each end. If the jaws are open a 1/4" then the handles read a 1/4".

I find these very useful. They are easy to use one handed. I don't own a set of the figure 8 ones, but I have tried them and these are MUCH easier.

You could change the shape of the jaws and make them asymmetrical, bigger, smaller any way you want as long as the pivot stays equal distance from the two ends.

I made my pattern out of cardboard and tried them before making the actual set.


img

Re: My Second favorite home made calipers.

#2

Thanks Barry

john lucas

>I have been looking at making some like this. I promised a friend I would make him a thickness gauge and will probably make a new one for me as well.

Re: My Second favorite home made calipers.

#3

Re: Thanks Barry

Barry Irby

>John, I posted this because I have not posted anything in a while and I saw your figure eight ones down below. I really do like these and find them very useful.

One thing I did not mention was that I laid them down on a flat surface and warmed the jaws with a heat gun so the tips close against one another. A torch might work if you are careful.

I think the part about the inner two surfaces of the handles being flush when they closed is very useful. You can be working a bowl or hollow form and really get a feel for where the bulges and transitions occur.

Been trying to figure out if it would be useful to puts some steps in the handles that represent different thicknesses.

For hollow forms, one straighter leg and one curved leg might be useful.

I assume that on the figure eight ones, both ends flex. On these, most of the flex is in the jaws, not much in the handles. Better I think.

Let me know if you make some and how you like them.

Re: My Second favorite home made calipers.

#4

Re: My Second favorite home made calipers.

Carol - headed home

>I am a bit confused, Barry.

Could you please post a picture of them in the closed position?