Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

odd job turning

Posts

odd job turning

#1

odd job turning

john lucas

>I haven't been turning a lot of personal work lately. I've had to do a lot of odd stuff. I turned a drawer pull to match the Oak one below. It was challenging because it's quite thin at the bottom of the finger hole and the circle is slightly off center. I glued scrap wood around the piece to make turning easier since it's 1/4" thick on the long parts.

The other pieces are adaptors a friend needed made out of aluminum.

Re: odd job turning

#2

Re: odd job turning 

john lucas

>


img

Re: odd job turning

#3

Steve Kubien

Re: odd job turning

Steve Kubien

>Looks good from where I am sitting. If you don't mind me asking, how do you price work like this? I assume materials plus an hourly figure of some sort (ie whatever your shop rate is)?

Thanks,

Steve

Re: odd job turning

#4

Re: odd job turning

john lucas

>exactly. Since I don't do a lot of this kind of work and I'm not a full time turner I charge by the hours and depending on the complexity of the material needed I may require they furnish the material. If I have to drive around to find the material there is an extra fee.

I do these mostly for the challenge and fun of doing something different. I sure don't get rich.

Re: odd job turning

#5

Re: odd job turning

Don wilcut

>You sure do make lots of friends John, at the moment.

Leaving this morning for JCC. Gonna have fun and that's needed for an old turner.

Re: odd job turning

#6

Dick Hines

Re: odd job turning

Dick Hines

>John I had a friend come by last week with an order for a set of cup holders for his street rod.

Re: odd job turning

#7

Don- stop by.

john lucas

>I'm only 2 miles off the interstate if I'm home. Your welcome anytime.