Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

PLUG CUTTER

Posts

PLUG CUTTER

#1

PLUG CUTTER

Carl Barton

>I am looking to do some inlays for a segmented bowl feature ring. What I want to do is cut a 1-1/2 hole and fill it with another species of wood. I have a 1/2 in cutter but I am trying to find a 1-1/2in plug cutter. I know someone must supply them but so far all I can find is a 1 in. Does anyone have a link out there for a supplier?

Thank you

Carl

Re: PLUG CUTTER

#2

Re: PLUG CUTTER

Rick_Allen

>WE MAKE ROUND THINGS!!!!!!!!!

Turn the 1 1/2" plug.

Re: PLUG CUTTER

#3

Re: PLUG CUTTER

john lucas

>check Lee Valley and Rocklers for Plug cutters. I use the smaller ones but for larger holes I just turn them.

Re: PLUG CUTTER

#4

Steven Antonucci

Thought the same thing

Steve antonucci

>face grain or end grain, your choice...

S

Re: PLUG CUTTER

#5

Re: PLUG CUTTER

Carl Barton

>Thanks to all for the advice. I thought of turning them but my plan is to fill the hole with 1-1/2 plugs, cut the wood into segments to form a ring. Then cut the ring in half flip both halves over and re-glue. So a 12 segement ring would require at least 13 plugs (one extra for any mistake). I am sure I could do it, but a plug would speed things up allot.

I know that this size is out there, I seen one before, just do not recall where.

Carl

Re: PLUG CUTTER

#6

Re: PLUG CUTTER

Pete in Holland, MI

>What about one of those adjustable fly-cutter type hole cutters? Just clamp your block to a rigid drill press table and run it without the pilot drill.

Re: PLUG CUTTER

#7

Re: PLUG CUTTER

john lucas

>The fly cutters will work if you remove the center drill and clamp the work firmly to the table. they do leave a somewhat ragged hole and you might have to regrind the cutter. If my memory serves me correctly it cuts a tapered edge on the inside of the hole. Flip the cutter 180 degrees so the old edge is up and then grind the proper edge on the new bottom and you should be able to make it work.

Re: PLUG CUTTER

#8

Bungs

Jorge Castaneda~Downeast Maine

>Carl,

Marine suppliers carry bungs of many sizes and several species.

Re: PLUG CUTTER

#9

Re: PLUG CUTTER

gary s clarke

>Look at Malcom Tibbetts book on the chapter for making portholes. Basically take a segment of wood and turn a tenon and put it in a chuck and then drill your hole with a 1 1/2 inch forstner bit. Turn your plug on the lathe and then after gluing in place cut your angles for your segment of choice.

Re: PLUG CUTTER

#10

Re: PLUG CUTTER

Bruce McElhaney, Spring Lake, Michigan

>Carl, I use the 1-1/2" stubby plug cutter available from Woodworkers Supply - http://woodworker.com/ Their larger sized plug cutters are not cheap, but are high quality. I use it along with a 1-1/2" forstner bit for the bottom plug in my segmented vessels. Woodworker Supply carries plug cutters in most all sizes up to 1-1/2" wide. They are the only place I've found that offers them that large.