Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Sanding & grain direction

Posts

Sanding & grain direction

#1

Sanding & grain direction

Thad

>The thread below reminded me of a curiosity I had last night:

One technique mentioned below is sanding by hand. I assume this refers to having the turning in one hand, and sandpaper in another, and no power tool. When hand sanding, do you sand with the grain (as much as possible) or does it matter since turnings typically get sanded so finely?

I thought about turning a flat spindle (just straight, no beads or coves), taping it in the middle, then sanding the two halves differently. Half "A" I would sand as I would any spindle, while half "B" I would stop the lathe, and progress through the grits sanding with the grain. What do you think the differences in the finish would be on each half?

~ Thad in middle GA

Re: Sanding & grain direction

#2

Re: Sanding & grain direction

keith zimmerman, Normal IL

>Whether or not I sand a spindle around the grain or not, I always finish up each grit by stopping the lathe and sanding with the grain to remove the round sanding scratches. This will leave a surface that will accept a finish quite nicely.

keithz

Re: Sanding & grain direction

#3

Re: Sanding & grain direction

Al Neighbors

>I believe that if:

1. You are very careful to sand with one grit, until the scratches from the previous grit are gone, and...

2. You sand through all grits of paper and micromesh... Then,

... you will not notice any difference, (with the piece spinning on the lathe.)

I also believe that if you'll stop the lathe, and sand with the grain, before you go to the next grit, it'll make the whole job easier.