Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

New use for double-stick tape

Posts

New use for double-stick tape

#1

Keith Tompkins

New use for double-stick tape

Keith Tompkins

>To sand the carved areas of my turnings, I usually glue a sheet of sandpaper to a piece of veneer with yellow glue, clamp it overnight, and then cut it into appropriate sized strips. The nice thing about this method is that the veneer prevents the sandpaper from cutting where I don't want it to cut...I can run the paper along a carved line without disturbing the line. Problem is, if I run out of strips, I have to go through the whole glue-up procedure. Well, I ran out, and couldn't wait for the glue to dry, so....I applied double-stick tape to pieces of veneer, and then added the abrasive paper. Voila! Back in business! AND, I can put a different grit on either side; works like a charm.

Re: New use for double-stick tape

#2

Re: New use for double-stick tape

Barbara Gill, Remlik VA

>Great idea, in fact I bet the editor of the Tips section of the American Woodturner might like that one.

Re: New use for double-stick tape

#3

Re: New use for double-stick tape

Cyril Griesbach

>Thanks for the tip, Keith. I would guess that the tape also makes the "sanding strip" more flexible.

Re: New use for double-stick tape

#4

Re: New use for double-stick tape

Carole Valentine

>Strips of fine sticky back velcro are even easier. I put them on thin wood or on those fake credit cards they are always sending in the mail then fold a piece of H&L sandpaper over to catch the strip on each side. I don't locate the strips all the way at the bottom of the carrier, but up a 1/2" or so. Easy to change grits or shift to a fresh area of sandpaper.

Re: New use for double-stick tape

#5

Dick Hines

Re: New use for double-stick tape

Dick Hines

>Send this to John Lucas. He is always looking for tips for the AAW Journal

Re: New use for double-stick tape

#6

Dick Hines

Re: New use for double-stick tape

Dick Hines

>For sanding boxes I wrap a piece of velcro tape around my index finger and stick a small piece of sanding disk on the velcro. Great for sanding the small boxes.

DO NOT DO THIS UNLESS YOU TURN YOUR LATHE DOWN AS SLOW AS IT WILL GO. If you do they may be calling you stubby.

Re: New use for double-stick tape

#7

Keith Tompkins

Re: New use for double-stick tape

Keith Tompkins

>I may try that Carole. I'm concerned that the edges aren't tight against the wood strip. With the glue, the sandpaper acts as part of the wood backing. I can flex the strip to fit a convex or concave spot, or cut it to fix a specific area without worrying about the paper slipping or shifting.

Re: New use for double-stick tape

#8

and then there is duct tape *LINK*

Bill McWhirter

>Here in the South were are always finding new uses for sticky stuff.


duct tape in use

Re: New use for double-stick tape

#9

Re: I have also used double sided tape....

Jamie Donaldson

>..to fasten sandpaper to craft sticks(Popsicles)in order to sand flats in carved basketweave and other flat areas in a confined space.

Re: New use for double-stick tape

#10

Re: New use for double-stick tape

Carole Valentine

>Keith, where a fine, thin edge is needed, or an odd, tight shape the tape is indeed better. I find uses for both. And like Dick, I use the sticky velcro on my finger, but sometimes I use the tape on my finger too. We have to do whatever works for a given situation!

Re: New use for double-stick tape

#11

Re: New use for double-stick tape

George Van Beynen

>Sounds like a great idea Keith, I will try it out this weekend. I have a roll that is not the perma-tape Wally recommends for faceplate that I should finally have a purpose for.

Re: New use for double-stick tape

#12

Re: New use for double-stick tape

mfoster

>I had need for the same thing on a number of the pieces I have been carving lately. I wound up buying rolls of adhesive backed sandpaper from Klinspor. I bought one of their bargain boxes and you get various grits in rolls from 2-4" wide. They are really handy. Just use whatever you need for a backer (wood strips, popsicles, or something more flexible like plastic from a cut up juice container) cut what you want from the roll peel off the protecter and stick it on and sand. Definitely beats dealing with double stick tape and I find it easier to use than velcro. If you make small backers, you can do some real detailed sanding like this. You can shape a wooden backer to fit into V's or odd shapes, and sand only one side of a V or corner depending on where you put sandpaper on the backer.

Klinspor sells regular aluminum oxide and stearated in the rolls and both are available in the bargain boxes. I like stearated sandpaper.

Re: New use for double-stick tape

#13

Dick Hines

Re: New use for double-stick tape

Dick Hines

>Double sided tape could be used as a mouse trap too. Just stick some on a board and place it nead the mouses home. Then all you have to do is wack him in the head. Mouse problem solved.

Re: New use for double-stick tape

#14

Keith Tompkins

Re: New use for double-stick tape

Keith Tompkins

>BTW, the double stick tape I'm using is formulated especially for adhering fabric to composite panels....very thin, but very good bond.