Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Would appreciate input re Chuck Replacement

Posts

Would appreciate input re Chuck Replacement

#1

Peter Charles Fagg (UK)

Would appreciate input re Chuck Replacement

Peter Charles Fagg (UK)

>I will seriously have to consider purchasing another chuck in the very near future.

I have many sets of jaws, faceplate rings etc. to fit my old chuck and to having to replace everything is going to be too costly and I must keep my production turning up and running.

Therefore I ask all of you and manufacturers, if the jaw mountings on your chucks have bolts at 13mm centres?

If there is such a chuck it is more likely to be purchased than one that does not match up to those dimensions!

Thanks to all for your patience, I will be posting this message on other forums to gain the greatest coverage.

Regards, Peter.

Re: Would appreciate input re Chuck Replacement

#2

Dick Hines

Re: Would appreciate input re Chuck Replacement

Dick Hines

>Peter, you did not say what make chuck you have now. If you like the one you have and they are still made go with that. I use Nova chucks because all the jaws that Nova makes will fit any of their chucks. I have a Super Nova2 , two of the older Novas and a Titan. Every set of jaws Nova makes will any of these.

Re: Would appreciate input re Chuck Replacement

#3

Peter Charles Fagg (UK)

Re: Would appreciate input re Chuck Replacement

Peter Charles Fagg (UK)

>Dick, thanks for the response.

I have contacted the manufacturers, Selbix, but they have ceased production, they did however supply me with drawings and new jaw fitting bolts FOC which was appreciated.

What I need to do is to replace the chuck, full stop, but retain all the extras!

I thought that one of your American manufacturers or one of our friends might be interested in supplying info as to an alternative.

Regards, Peter.

Re: Would appreciate input re Chuck Replacement

#4

Dick Hines

Re: Would appreciate input re Chuck Replacement

Dick Hines

>Peter, I don't think there are any chucks made in the US.OneWay may be the only one made in North America.

Re: Would appreciate input re Chuck Replacement

#5

Brad Vietje

Re: Would appreciate input re Chuck Replacement

Brad Vietje

>Charles,

I'd contact Oneway, and ask if they will make up a few sets of custom jaw slides for you with the proper spacing. I suspect they'd be willing for a fee.

Safe spinning,

Brad Vietje

Newbury, VT