Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Marbled 2 Piece Maple Tops

Posts

Marbled 2 Piece Maple Tops

#1

Marbled 2 Piece Maple Tops

Greg Haugen

>I recently demonstrated marbled 2 piece maple tops for our club. Here is a sample of a few of them, a couple from the actual demo and a couple that were made to prep for the demo. The discs are a little under 2" diameter. Finish is Behlen's Rockhard Table Top Varnish thinned with Mineral Spirits (60 varnish/40 spirits).

Comments welcome.


img

Re: Marbled 2 Piece Maple Tops

#2

Steven Antonucci

Those are very cool!

Steve antonucci

>What are the two pieces? the spinner and the disk? Is it a stepped hole?

Steve

Re: Marbled 2 Piece Maple Tops

#3

Re: Those are very cool!

Greg Haugen

>Thanks Steve.

Yes, the disc is one piece and then the axis/shaft is the other. No, it's just a single hole. After I drill it, I use a 1/8" round nose scraper I made out of a chainsaw file to "true" the hole. Since it's a top, the hole has to be perfectly true as possible so it spins the best it can. After marbling the disc I turn the axis, cut a slight recess in the "button" portion of it's bottom so it seats flush against the contour of the disc. I turn it so it's a good snug fit. A drop of CA will forever secure it.

These are a project on Alan Lacer's Son of Skew DVD.

Thanks for the comments.