Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

The hollow form I was working on...

Posts

The hollow form I was working on...

#1

The hollow form I was working on...

Marc Phillips

>This is it... from a multi-crotch piece of Sweetgum... literally cut from the intersection of 3 limbs and the trunk... grain was going all over the place (cool!) and there was lots of grain challenges and the spalting made for some extra fun too... sorry to say even after using CA here and there, sanding again, more CA etc. it still cracked...

After reading the responses from my earlier post I now know that leaving it on the lathe contributed to the cracking...

I had lots of successes with this though.... the hollowing started off like a war... just couldn't seem to find the right combination of tool rest height, which cutting tool, which angle to grind the cutting tools, and even which cutting tool to use and when! .... but about 3/4 of the way through the hollowing I finally started getting nice clean passes and some good shavings.

I really want to do hollow forms, so I am going to keep working at it until I at least know what tool to use and where, tool rest height, and on and on...

9" tall, 6" wide at the widest point... 3/8" thick all over, except the very bottom is about 3/4" or so... simply could not get down into the form that deep. I will try using a bowl gouge to get that final bit near the bottom next time.

The sister of this log is going to be in the blank exchange... I have it Anchorsealed and drying...

Anyhoo, here it is... and thanks for looking :)


img

Re: The hollow form I was working on...

#2

The other side... 

Marc Phillips

>


img

Re: The hollow form I was working on...

#3

Re: The other side...

Al Neighbors

>Mark, you sound just like I did when I first started turning hollow forms. Exactly like my first ones.

I turned the inside of all my hollow forms with oland tools... or variations of it. I bent some of them into swan necks.

I found that, regardless of which tool I use, the upper left quadrant of the piece is where I cut, especially when scraping smooth. Because, when you're cutting at or above centerline (upper left quadrant), the wood is rotating 'away' from the cutter. If you drop below the center line, the wood is rotating 'toward' the cutter, and a catch is more likely.

For reaching as deep as you did in this piece, a smaller cutter will allow you to cut farther across the toolrest. I.E., with a 3/4" shaft, you might reach 4" across the toolrest with a 1/4" cutter before you get chatter. But a 3/16" cutter will let you reach 2" farther, and a 1/8" cutter will let you reach another 2" beyond that.

Hope this helps a little. By the way, good looking hf. :)