Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Laquer over oil

Posts

Laquer over oil

#1

Laquer over oil

Chris Krohn

>Just trying out some finishes on my turnings. On a piece or two I just sprayed rattle can laquer and was unimpressed with the finish, it seemed like it did not bring out the grain to the fullest. Also I have been turning some natural edge with a lot of voids within the bowls (manzanita root burls) and it seems it is hard to get in the crevices without overspraying and getting a run.

Next question... is spraying laquer over oils a problem? I found that using the oils first gets good coverage in the cracks and crevices, as well as bringing out the grain. Then it seems like they need more coats of laquer.

Re: Laquer over oil

#2

Re: Laquer over oil

Dick Coers

>As long as the oil is good and dry, no problems. I usually spray the first coat a little dry, then nice wet coats after that. Shellac is also a good base coat for lacquer. I don't use any rattle cans. They have very poor nozzles, and don't atomize the finish very well. Look at some cheap touch-up guns to spray your lacquer.

Re: Laquer over oil

#3

Re: Laquer over oil

Chris Krohn

>What do you mean atomize? Will the lacquer be less likely to run if the first coat is light?

Re: Laquer over oil

#4

LACQUER (I am not a spelling bee champ)

Chris Krohn

>

Re: Laquer over oil

#5

Re: Laquer over oil

Paul Zerjay

>Ever try spraying lacquer with an airbrush? Kinda like HVLP, as you can turn it down so low, there's no over-spray. But with an airbrush, you have a very small container to have to deal with after your done, unlike a big ole cup from an HVLP gun.

Re: Laquer over oil

#6

Re: Laquer over oil

Texian

>All rattle can lacquer nozzles not created equal. Of 4 or 5 tried, prefer Deft brand.

Spraying lac. has learning curve. Results vary greatly with distance and speed of traverse, and both these may vary depending upon whether you are doing 1st, 2nd coat, or final two coats.

Re: Laquer over oil

#7

Re: Laquer over oil

Chris Krohn

>you are definetly right there. You only do four coats?

Re: Laquer over oil

#8

Re: Laquer

michael j. neitzel

>What is the proper way to spray finish with an hvlp spray system, and nitrocellulose lacquer? Any good reference materials? Advice!

I'm using the grizzely guitar finish set-up now.

Anything better than that?

Thanks,

mike