Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Skew in use picture

Posts

Skew in use picture

#1

Skew in use picture

Terry Scott

>Charlie ,here is a picture of how I place my skew to turn the winged vessels I make

Because I am turning cross grain ,I find it's the only way that I don't tear the wings off as the corners of the square come down onto the bevel

If a spindle gouge is used it picks up the end grain and it is all over rover

My recommendation is anyone wanting to try this (don't L.O.L) is to practice on a round piece of wood first.

I am only cutting with a 1/16 of the tip with the bevel rubbing .To practice mark the bevel of the skew on both sides with a felt tip leaving a 1/16 of an inch ,If a black mark appears on the work face you are cutting into the danger zone.

Please remember I have turned hundreds of winged vessels this way and are vary aware of what causes a mishap ,be careful

If you go to my web site www.timberly.co.nz you will see some work 600mm 2ft square that I have turned with this method ,cutting in until the handle is hitting the wings ,work the cut from side to side in a V

Cheers


img

Re: Skew in use picture

#2

Re: Skew in use picture

Terry Scott

>sorry I forgot to say ,you have to wind the speed up

cheers

Re: Skew in use picture

#3

Re: Skew in use picture

Carole Valentine

>Terry, I think you must a danger junkie! I would no more have the nerve to use a skew like that than to stand in front of a freight train. Yikes!

Re: Skew in use picture

#4

Re: Skew in use picture

john lucas

>Terry I've been using that cut for years for everything from goblet bottoms to tucking in tight areas between the bowl and an extended foot. I find it very useful to clean up the area just before the foot of a bowl when reverse turning the bowl. I also use it a lot when doing the initial cutting of the shoulder area on inside out turnings. I haven't tried it on a winged vessel yet so I guess I'll have to head out to the shop and go at it. Thanks for posting.

Re: Skew in use picture

#5

Re: Skew in use picture

Jorge Castaneda~Downeast Maine

>Terry,

That is quite a mastery of the skew.

I use it to clean the bottom of bowls only, or as a parting tool, never to shape the piece like when turning between points.

Thanks for showing us. As John said, now have to try it...

Jorge

Re: Skew in use picture

#6

Re: Skew in use picture

Terry Scott

>John try coming around the whole bowl from foot to rim ,keep the handle well down ,cut with 1/16 of the toe rubbing the bevel .or place the skew at a 30 degree angle and use as you would a share cut on a a swept back winged bowl gouge same cut but without the other side of the flute

I have started doing a planing cut as well like Guilio showed me.many of my bowls know I start sanding with 240 grit .On hard wood bowls I use the skew and share cut the inside as well

The joke is I couldn't use the skew on spindle work if I tried

Cheers