Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

OT: Steel Question

Posts

OT: Steel Question

#1

OT: Steel Question

TomCollins

>A lot of you seem to know a lot about the different grades of steel so I thought I would ask here. My mower deck has a 1/2in rod that runs the width of the deckh rollers on it that support the back of the mower. The original rod took a lot of abuse (12 years)but I finally bent it. I replaced it with a rod from Lowes last spring and fought with it all season getting it bent back into place after each mowing. I need to replace the rod again this year. I am wondering what grade rod should I look for that will stand up to the abuse. I need to be able to drill a couple small holes in it but could use a spot weld if necessary.

TIA,

TomCollins

Re: OT: Steel Question

#2

Re: OT: Steel Question

john lucas

>tom I'm certainly not an expert here but you can buy drill rod from Enco almost as cheap as the cold roll from Lowes and it is a lot stiffer. I don't know if it would do what you need to do however. it comes soft so it can be drilled.

Re: OT: Steel Question

#3

Dennis in Southern Oregon

Re: OT: Steel Question

Dennis in Southern Oregon

>Tom,

Would it be practical to replace the rod with a larger diameter rod, perhaps reboring any pieces that the rod has to pass through? The stiffness of a rod increases VERY fast with increased diameter. Dennis

Re: OT: Steel Question

#4

Thompson Tool steel

Dave Peebles Lyons, Ohio!

>Sorry Tom...

I couldn't resist. :)

I hope you get a better answer..

Dave

Re: OT: Steel Question

#5

Re: Thompson Tool steel

TomCollins

>Not a bad idea Dave, I could sharpen both ends for turning, design a snap-on handle and have a real multi-purpose tool. I need to get busy!

Missed you Saturday.

TC

Re: OT: Steel Question

#6

Re: OT: Steel Question

Don Evans

>You have two factors to consider.

One is with hardness comes brittleness. You reach a point in making it hard enough to do the job but not going over that point and making it brittle.

The secret to the highly prized Japanese swords is their softer inner core with harder steel around it. Same for Domascus steel.

Two rods one solid and one hollow which is stronger, with all other things equal about them the hollow one is the strongest is some applications.

I think the problem you have is very complicated and may be only cured by purchasing original parts if still available.

Don

Re: OT: Steel Question

#7

redesign?

John K Jordan

>Tom,

It's hard to engineer a fix without seeing the mower, but it may be possible to prevent bending by either reinforcement (e.g., weld a stiffening rib or brace to the 1/2" rod), by adding one or more brackets with 1/2" holes to support the rod at the critical points, or by creating a stronger rod, e.g., welding short 1/2" sections to a stronger support, perhaps made from heavier round or square rod or square tubing. It might even work to slide sections of square or round tubing over the 1/2" rod. A picture of the problem might suggest a simple solution.

Also, for a stronger rod you might check with a local machine shop and explain the problem. One I know of kept stock in a variety of alloys.

JKJ