Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Spalting?

Posts

Spalting?

#1

Spalting?

Randy Johnson Connersville IN

>Yesterday I made a bowl out of some catalpa that I brought into the shop about two weeks ago. It was cut from some large trunks that had been bulldozed out of the way after falling onto some cultivated ground. I�m guessing that the trunks have been there about a year or so. It works just like freshly cut wood.

I decided to let the bowl sit for a day or two before applying a finish. Shortly after taking it from the lathe I noticed a few small black spots that looked like paint splatter. At the time I didn�t give it much thought.

When I went to the shop today, there were a LOT of black spots. Thinking it was something that could be killed with a good dose of alcohol, I poured some in the bowl and wiped it liberally over the entire surface. This caused even more black spots to appear. I guess this is something akin to spalting but it doesn�t appear in lines. It looks like small flecks of black paint and, unlike regular spalting, detracts from the appearance of the wood. It is not evident in any of the yet to be turned wood. It did not appear in any of the three previously made pieces that were made from the same source.

I�m wondering if anyone else has encountered this, and if so, how did you deal with it?

Re: Spalting?

#2

Steven Antonucci

Likely tanin stains from you tool steel

Steve antonucci

>Some woods will react with iron and create tanin stains. If you had little pieces of the edge of your tool or used steel wood on the finish, the reaction could happen pretty quickly.

S

Re: Spalting?

#3

Re: Spalting?

robo hippy

>Metals will oxidize/rust when they come into contact with water. Some woods with a higher tanin content like oak or walnut will react more. After sharpening a gouge or scraper, there is usually some metal dust on the tool. These small particles can show up as black spots on the wood. You can remove them with concentrated lemon juice, and I believe a boric acid solution works as well. I do this a lot to remove the iron stains from my chuck jaws. Doing it to a whole bowl might be a problem. The juice needs to sit for 5 or so minutes, and the stains can some times sand out on side or flat grain, but not on end grain where the stain penetrates a lot deeper.

robo hippy

Re: Spalting?

#4

Re: Likely tanin stains from you tool steel

Randy Johnson Connersville IN

>Okay, that would explain why it got worse after alcohol was applied.

I usually hate to do any kind of staining but that's what I did in this case. Live and learn.

Thanks

Re: Spalting?

#5

Re: Spalting?

Mike Jones, Redding, CA

>Do You chew? :)

Re: Spalting?

#6

Re: Spalting?

Randy Johnson Connersville IN

>Nope, but I've been around enough people who do to know that it would cause BIG brown stains, not small black ones.

Re: Spalting?

#7

Brad Vietje

Re: Likely tanin stains from you tool steel

Brad Vietje

>Randy,

All is not lost. As Robo says, apply Lemon or Lime juice. I had made a real mess of a natural-edge Red Oak bowl that I liked a lot, and completely saved it by rubbing it all over with a few fresh Lime wedges, squeezing the juice right into the wood. Let it stand over dinner/ball game, then rinse off. After the wood is dry youo'll have a tad more fine sanding to do, but you should be OK.

Let us know if it works!

Safe spinning,

Brad Vietje

Newbury, VT