Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Carving carousel - Rev 0

Posts

Carving carousel - Rev 0

#1

Carving carousel - Rev 0

George in Minnesota

>I just finished the putting together my first attempt at a carving jig that I can rotate, tilt while keeping the turning on a chuck or faceplate. I took a couple pictures on my iPhone and they are enclosed. I haven't epoxied the bolt in since I am not quite happy with the shape of the of carousel. I am also on the fence as to whether I want to put an indexing system to fix the carousel. The hardware is straightforward from Rockler. I am looking for critiques as well as suggestions. I would prefer to find better sliding hardware rather than the chest hardware used.

Thanks

George


img

Re: Carving carousel - Rev 0

#2

Re: Carving carousel - Rev 0 (2nd Picture) 

George in Minnesota

>


img

Re: Carving carousel - Rev 0

#3

Re: Carving carousel - Rev 0

Texian

>Despite being unable to carve my way out of a sack, I still think that you will want an indexing and locking feature on the rotating (not the tilt) mechanism. Maybe just need "marks" every 22.5 degrees to align up to 16 flutes (or other musical item). Just a thought.

Re: Carving carousel - Rev 0

#4

Re: Carving carousel - Rev 0

bob elliott

>I would suggest that you keep it simple and forget the indexing system. Put a nut on the stud (bolt) and a flat washer followed by the chuck to lock the chuck at any desired position of rotation.

Re: Carving carousel - Rev 0

#5

Mount in a sturdy bench vise?

Jerry Hall

>I have been playing around in my mind for some time with a fixture somewhat like yours but with a length of 1-1/4 x 8 threaded rod double nutted into the end of a 4 x 4 by 16 or so. Pre-drill a clearance hole for the rod and epoxy one nut at the top.

And then clamp the 4 x 4 into my sturdy bench end vise. This would give me 270 degrees access, and I could easily tilt the post to my needs. And rotate the work by loosening the nut. Probably mount the threaded rod at a bit of an angle to the post to give me better positioning options. It seems to me it would be quite sturdy and I would have the use of my bench for tools and coffee. Just some thoughts. That said, a sand bag on the bench, or occasional strategic use of a bench hold down has gotten me by so far. Keep us posted on your progress! I have the nuts and threaded rod. Maybe I will finally get to it with your post encouraging me.

Re: Carving carousel - Rev 0

#6

Re: Carving carousel - Rev 0

Don Evans

>I agree the hinges have to go, they are too light weight. Consider a wedge that will slide between the two brown pieces.

Sliding the wedge in and out the back side will raise and lower the angle of the top brown piece.

You will definitely need to add something to the round part and the wedge that allows you to lock then.

Don