Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Pen blank problems

Posts

Pen blank problems

#1

Pen blank problems

Jim Rutten

>I was working on drilling out one of those acrylic pen blanks on the lathe. I had the blank secured on the inside of the chuck and was using my jacobs chuck to hold the drill bit. I was drilling a little and then backing out but somehow it bound up tight and I can't seem to go forward or reverse. I don't care about the pen blank, but would like to save the drill that is stuck in it. any thoughts?

Re: Pen blank problems

#2

Re: Pen blank problems

Ed Davidson (Colorado Springs)

>Jim,

Try putting the blank/bit in the freezer for an hour or two. That should break the bond and allow you to disengage.

For future reference, slow your lathe and/or drill press down to 200-400 rpm when drilling plastic blanks...some plastic materials tend to melt and will bind up with high speed drilling.

Re: Pen blank problems

#3

Re: Pen blank problems

Jim Rutten

>Thanks, Ed. I'll give it a try.

Re: Pen blank problems

#4

Re: Pen blank problems

Ken Oakley-Sunny St. Cloud, Fla.

>Another suggestion--lubricate the hole liberally with mineral oil as you drill.

Re: Pen blank problems

#5

Re: Pen blank problems

Gary Evans Tallassee, TN

>Jim,

If you don't care about the blank, acrylic plastic breaks pretty easy. Squeezing it in a vise should be controllable.

Gary