Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Morse Taper Question

Posts

Morse Taper Question

#1

Morse Taper Question

Ken Oakley-Sunny St. Cloud, Fla.

>I have my fathers Craftsman Model 109 metal turning lathe and it has only a dead center in the tailstock. There is a MT#0 drill chuck on eBay and I think this lathe takes a MT#0 but am not positive. Is there an easy way to find if it is #0?

Re: Morse Taper Question

#2

Re: Morse Taper Question

Ken

>unless someone come forth who has one,I would suggest you pull up craftsman lathes an put in the model no an it may give you the specs on it.It seems that I read somewhere that it takes a #1,but am not sure.Good luck

Ken

Re: Morse Taper Question

#3

Re: Morse Taper Question

Jim Pugh, Elyria, OH

>Ken, my Machinery's Handbook says the large diameter of a #0 MT is .3561. This is the large end of the socket it fits into, ie the opening in the tailstock ram. The same feature for a #1 MT is .475 so you should be able to quickly determine which you have.

OT: A few weeks ago I was listening to Clark Howard on the radio and he spoke to a Mrs. Ken Oakley from Florida. Might that have been your bride?

Re: Morse Taper Question

#4

Re: Morse Taper Question

Ken Oakley-Sunny St. Cloud, Fla.

>I doubt my wife spoke with Clark. She gets annoyed when I try to tell her about something he said. My wife is Financially Challenge. She is more Oprah/Nancy Grace/Martha Stewart oriented.

I will mic the opening in the quill. Thanks for the hint. By the way this lathe was made by Atlas and is a relly nice little lathe. My father purchased it new in 1947. They appear on eBay often and have never seen one that didn't sell.

Re: Morse Taper Question

#5

Re: Morse Taper Question

Ken

>WOW Ken that is an oldie.They probably sell well cause back then american made tools were made to last.Good luck with it.

Re: Morse Taper Question

#6

Re: Morse Taper Question

gtwilkins

>Ken,

Found this information a couple of days ago when I was looking at an Atlas Craftsman lathe made by the Atlas Press Co.

http://www.woodcentral.com/cgi-bin/turning3.pl?form=204523

Hope this helps,

Trevor in Snowy Powell River

Re: Morse Taper Question

#7

You Think That is Old--

Ken Oakley-Sunny St. Cloud, Fla.

>I was 15 when he bought it. But I have been told they don't make them like me anymore.

Re: Morse Taper Question

#8

Re: Morse Taper Question

Ken Oakley-Sunny St. Cloud, Fla.

>Trevor- That link takes me to post response page. There is nothing on it.

Re: Morse Taper Question

#9

I Measured the Hole in The Ram

Ken Oakley-Sunny St. Cloud, Fla.

>It measures .338" so it must be a Morse Taper #0. Now off to bidding.

Re: Morse Taper Question

#10

Re: Morse Taper Question

gtwilkins

>Sorry Ken try this:

http://www.owwm.com/mfgindex/detail.aspx?id=51&tab=4

Trevor