Re: Hollow form bottom work
eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---
>Probably the easiest way is to turn a scrap so it more or less fits over the top of your hollow form. Then hold your piece between it, at the head stock, and the tail stock revolving center. Then clean up your base however you want and, finally, take off the form and just cut off the little nub that's left on the bottom with a sharp chisel. I always use a very sharp, cheap, little curved carving tool only for that purpose. Another way is get hold of a Kone holder. It's basically a rod of metal with a morse taper that goes in the headstock spindle. At the other end there's a small pad. And there's a cone-shaped wooden part that slides along the rod. The idea is to put the rod through the opening in your nearly finished hollow form and slide it all the way to the bottom of the form. Put the morse taper in the headstock spindle and bring up the tailstock live center to squeeze the form between the bottom of your form -- from the inside -- and the revolving center. You also slide the one-shaped wooden part up to the opening in your form for stability. Then you turn away!