Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Stuck chuck, Hey Ruth! Hey canuck!

Posts

Stuck chuck, Hey Ruth! Hey canuck!

#1

Stuck chuck, Hey Ruth! Hey canuck!

Jorge Castaneda~Downeast Maine

>It is my turn to have this predicament, my Stonghold is just doing that, not to the platter I was turning, but to the spindle, how I am going to take it out? Can I borrow Ruth's wrench? I need this chuck out and my vacuum chuck in, shezzz.

Things were moving along quite nicely and now this...

ANy advice will be greatly appreciated

Thanks

Jorge

Re: Stuck chuck, Hey Ruth! Hey canuck!

#2

Jesper, Denmark

Re: Stuck chuck, Hey Ruth! Hey canuck!

Jesper, Denmark

>Lock the spindle, put the key in the chuck and give the key a sharp rap with a hammer in CCW direction. A real hammer, not a soft one. Not a BFH either.

Re: Stuck chuck, Hey Ruth! Hey canuck!

#3

Bimgo!!

Jorge Castaneda~Downeast Maine

>Jesper,

I tried las night with a rubber mallet, then with an oak mallet, afraid to damage the chuck. After reading your advice, I went with a 16 oz hammer, nothing, then with a 28 oz one, same, so I got a small sledge, and verbally explain the chuck it better get dislodge or I'll beat the living yesterday's out of it's tomorrows, it came out at the first whack!

Thank you very much, I owe you a cold one.

Jorge

running back to the shop

Re: Stuck chuck, Hey Ruth! Hey canuck!

#4

It was the verbal persuasion that did it :)

john lucas

>

Re: Stuck chuck, Hey Ruth! Hey canuck!

#5

Re: Stuck chuck, Hey Ruth! Hey canuck!

John K Jordan

>Yikes, I cringe when I see people whack the chuck key to loosen the chuck. I have a damaged key that I suspect came from this, and it can't be good for the chuck.

I don't know about other brands, but Technatool makes a nice wrench that fits the hex insert on the Supernova chucks.

JKJ

Re: Stuck chuck, Hey Ruth! Hey canuck!

#6

Re: Stuck chuck, Hey Ruth! Hey canuck!

Bill Howatt

>I don't like the method either. I have Oneway chucks and haven't had the problem but I speculate that you could find/make one of those "C" shaped wrenches that would fit in the M8 spindle lock holes in the adapter or even a bigger one that would fit in the large key holes in the body.

Bill

Re: Stuck chuck, Hey Ruth! Hey canuck!

#7

Jesper, Denmark

Re: ell You what...

Jesper, Denmark

>If I ever get another chance to sail in Penobscot Bay, you can lead me into the tickle to get to the anchorage west of York Island. I am afraid that Swifty's sailing days are over, and I would probably wet my Newport Pink pants trying it alone.

Re: Stuck chuck, Hey Ruth! Hey canuck!

#8

Re: ell You what...

Jorge Castaneda~Downeast Maine

>Jesper,

I can give you a hand, and if you are not up to sailing but want to get to York Island anyway, there's a couple friends that can take us there...

Hope it happens, looking forward to it.

Take care

Jorge