Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Vaccuum Pump Pending.

Posts

Vaccuum Pump Pending.

#1

Dick Hines

Vaccuum Pump Pending.

Dick Hines

>Well after a lot of looking at web sights and reading I have ordered all,I hope, the stuff to build a vacuum system. I have less than $200 tied up. I am sure I will need a few other pieces but I live close to two box stores.

Thanks to all that helped me especially Jeff Williford and Sam McGarrity who called me to give all the information I could think to ask far.I new I could count on the Wood Central pack to help out.

Re: Vaccuum Pump Pending.

#2

Re: Vaccuum Pump Pending.

Carole Valentine

>Jeff and I should have mine hooked up tomorrow afternoon. He picked up the rest of the things we needed when he was back in civilization (across the Bay) this weekend. When he gets his pump, we will work on his. I have been putting a sealing finish on some MDF faceplates. Going to go get some PVC pipe fittings tomorrow. I have one store-bought drum chuck, but it's only 3 1/2" and I wanted a couple of larger ones.

Re: Vaccuum Pump Pending.

#3

Dick Hines

Re: Vaccuum Pump Pending.

Dick Hines

>Carole go to McMaster-car and check out some stuff called ultra-high molecular weight polyethylene(UHMW)It can be turnerd like wood and can be threaded too. I have used it to make centering cones for my live center. I have a piece that is 5:"D X 3" H. I am going to tap some threads in the back and put a face plate on. The drill a howl through the bottom. A little fun foam and I think it will work. There should be no air leake.

It can be taped with the Beall spindle tap and forgo the face plate.

Will let you know how it works.

Re: Vaccuum Pump Pending.

#4

Chat vac

Dave Peebles Lyons, Ohio!

>Hi Dick,

I knew it was gonna happen after the chat on Wednesday. :)

You will not be sorry...This is one of the few things that really suck, but in a good way. :)

Dave

Re: Vaccuum Pump Pending.

#5

Re: Vaccuum Pump Pending.

Carole Valentine

>Wish I had thought about that stuff when I placed my order with McMaster Carr. :(( I already have a Beal tap for my spindle but I don't have an over-abundance of faceplates. BTW...McMaster (and Packards) got my stuff to me in two days!

Re: Vaccuum Pump Pending.

#6

Rob Wallace

Re: Vaccuum Pump Pending.

Rob Wallace

>I've said this for years:

"Once you go vac, you'll never go back....."

;^)

Rob

Re: Vaccuum Pump Pending.

#7

Dick Hines

Re: Chat vac

Dick Hines

>I will send you the bill for all the parts Dave. I take cash or check.

Re: Vaccuum Pump Pending.

#8

Re: Vaccuum Pump Pending.

Dale Bright

>I used hard maple and the Beall Tap to make my chucks. Just make sure you face off the maple really flat. For my Jet 1642, I first drilled a 1 1/4" hole 1/4" inch deep and then drilled with the 1 1/8" bit all the way through the maple and tapped all the way through. Mounted the maple with the the 1/4" recess toward the tailstock and lightly trued faced off that side. Turn the blank around and fully seat and then do the rest of the turning and mounting of the PVC pipe. The hard maple works great and I do not get any leaks.