Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Indicating a pc of allthrread

Posts

Indicating a pc of allthrread

#1

Indicating a pc of allthrread

paul waddle

>How does one go about indicating a pc of allthread to run true in a 4 jaw chuck? Would an indicator with a wide foot to span the pitch work? My talon chuck runs true + - .003 on my jet lathe,but when I screw it on pc of all thread plus a collar its off more.I've been told that spindle threads are not necessarily snug,its the square abutment to collar to be true for accurate chucking. This gets back to orignal question,if I can indicate the allthread,then I can accurately face the collar.Thks pw.

Re: Indicating a pc of allthrread

#2

Re: Indicating a pc of allthrread

Dick Coers

>The wide foot should work, or maybe try holding a thin feeler gage between the standard foot and the thread. If it's thin enough, your hand should not affect the results.

Re: Indicating a pc of allthrread

#3

Re: Indicating a pc of allthrread

paul waddle

>Thks Dick,pw

Re: Indicating a pc of allthrread

#4

Re: Indicating a pc of allthrread

Gary Evans Tallassee, TN

>Hi Paul,

I'm having a little trouble understanding exactly what you are trying to do. Are you chucking the all-thread into your talon and then screwing the collar on so that you can face off the collar?

If so, I'd be surprised to find a piece of all-thread that was straighter than .003".

Gary

Re: Indicating a pc of allthrread

#5

Re: Indicating a pc of allthrread

paul waddle

>As it turns out,I didn't to need to indicate the althread. I put the Talon chuck in my metal lathe,indicated the insert,put a pc of 1x8 althread in the insert,drilled the pc 1/2"x1 1/8",stuck (literally) a pc of 3/4-16 shafting in the hole(a section was turned down to 1/2") with J B Weld. What I did,was adapt the Talon to 3/4" shaft. Waiting on the glue to dry so I can see if it runs reasonalbly true~ .003. If this doesn't work,I'll try it a different way. I'll take the 3/4 shaft,glue on a sect of 1 1/8 round stock,indicate the shaft,turn down the larger section and thread it for 1x8.Don't believe this method is as accurate however.pw