Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

My Version, CiL easy roughing tool

Posts

My Version, CiL easy roughing tool

#1

My Version, CiL easy roughing tool

Mitchell Cholewinski

>This picture is my version of the very popular CiL easy roughing tool. The original tool is made from stainless but I made mine from steel.I have several carbide cutters so I wanted another tool so I didn't need to change carbide cutter so often. My tool cuts just as good as the one I bought because it has the same carbide cutter. The price of my tool is under $14 whereas the original tool I bought was over $230, I believe, for the tool ,handle, cutters and shield. Both are good deals. Some turners hate to sharpen I love to sharpen, but dislike to change cutters, go figure why. Mitch


img

Re: My Version, CiL easy roughing tool

#2

Re: My Version, CiL easy roughing tool

Dennis Yoder

>What cutter are you using?

Re: My Version, CiL easy roughing tool

#3

Ditto, Dennis. :o)

Al Neighbors

>

Re: My Version, CiL easy roughing tool

#4

Re: My Version, CiL easy roughing tool

Mitchell Cholewinski

>Dennis Yoder

The carbide cutter that I have on this tool I made was the four sided square cutter that has no radius of any kind, I have two of these cutters and one with a 4" radius and one with a 2" radius. this is good for roughing. Mitch

Re: My Version, CiL easy roughing tool

#5

Rob Wallace

Re: My Version, CiL easy roughing tool

Rob Wallace

>Mitch:

What are the dimensions of the cutter(s) you used? 12 mm? 14 mm?

Also, how thick are the cutters? (There are lots of cutter options out there.....)

Do you find any difference in performance between radiused and straight cutters?

Inquiring mind want to know!

Thanks,

Rob

Re: My Version, CiL easy roughing tool

#6

Re: My Version, CiL easy roughing tool

Mitchell Cholewinski

>Rob

These cutters aren't in mm, they are approx 5/8" square and probably 1/4" thick. The sides are beveled and probably sharpened at 45 degrees.Yes of course there is a difference in straight cutters and radiused cutters, depends what your doing at the time which cutter you will be using. If your plunge cutting you would be using a straight square cutter. Round cutter would be used in inside finish cutting. Mitch

Re: My Version, CiL easy roughing tool

#7

Re: My Version, CiL easy roughing tool

Woodie49

>Any details on how you made it?

Thanks

Re: My Version, CiL easy roughing tool

#8

Re: My Version, CiL easy roughing tool

Mitchell Cholewinski

>Drilled a hole, tap it and install the cutter. Mitch