Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Saved a bowl...

Posts

Saved a bowl...

#1

Saved a bowl...

Marc Phillips

>Heya...

I turned this bowl with a rounded lip that turned under a little... but the edge still had (apparently) too much pith near it and it cracked ...

After a couple of weeks went by (today) I put it back on the lathe and parted off the cracked rounded rim, and turned it thinner and to a different shape...

It's 9 1/2" X 4 1/2" now...

I'm just happy it isn't in the wood bin as scrap!


img

Re: Saved a bowl...

#2

Re: Saved a bowl...

Donna Banfield

>That's a fine looking save, Marc. Smooth, continuous curve through the entire exterior. Looks like you did a very good job on that save.

Looking forward to a photo of your natural edge oak bowl that you're working on, from earlier post.

Re: Saved a bowl...

#3

Great save- really nice shape.

john lucas

>

Re: Saved a bowl...

#4

Re: Great save- really nice shape.

Cyril Griesbach

>Nice form, nice wood, nice save. How are things working out on the bottoms after all the good info you got?

Re: Saved a bowl...

#5

Lots better than scrap, good form

Dennis Yoder

>

Re: Saved a bowl...

#6

Dick Hines

Re: Saved a bowl...

Dick Hines

>Good save.

Re: Saved a bowl...

#7

How did you...

Mark in B'ham, AL

>remount the bowl on the lathe. I have trouble when ever I have turned off the mounting tenon and have to figure out how to spin a bowl again. Recentering is always my biggest problem.

Re: Saved a bowl...

#8

Re: How did you...

Marc Phillips

>There was a tiny dimple on the bottom that I used to center the tailstock and then used the tailstock to push the bowl against a cushioned chuck (used an old bathroom rug cut up)