>After a demo at my club, I've decided to look into getting a set of thread chasing tools. The only set I've found was thru Craft Supplies, a Sorby set. I've looked at Woodcraft and some other sites but I haven't had any luck thus far. Can anyone suggest other options regarding where I could look for thread chasing tools. Thanks.
>I got a brand new old stock set on ebay 3tpi-30tpi for $80. It was inside and outside sets, from Bay State. My guess that the fair price would be more like $800 plus. Alan Batty looked them over and said I got a steal.
But they do show up and seem to run about the same price there as you can find from Packard and CS. I tend to look at them just in case another deal comes by.
>for a really nice set of thread-chasers. He sells them for less than $80 and he tests each chaser. They are excellent quality. They come with a neat handle made by Mark. Actually, the handle allows you to reverse the steel, one end of which is for female threads and the other for male threads.
I don't know if they are on his website, listed below, but you may contact him through his site.
>I sent mark a letter and asked about the tools. He sent me a photo and says that he has them in 16 and 20 tooth varieties. $70 +$5 for S/H. here is a photo.
>The three piece set of thread chasing tools (16 tpi only I believe) that I prefer is made by Ray Iles in England and imported to the USA by Tools For Working Wood in Brooklyn, New York. This set fits my hands better that any other set I own, and I have sets of most of the chasers on the market, except the set that Mark St. Leger is selling.
If you want to go cheap, get a grade 8, 3/8" bolt about 8" long. Cut off the head and mount the un-threaded end in a handle. Then grind away the threaded portion to a flat as close to the center as possible. This provides both inside and outside chasers on one piece. It is cheap, and it does work. A tap can also be used in the same way, but you need an extension shaft.