Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

chuck slides

Posts

chuck slides

#1

chuck slides

clay rose

>one of the screwholes that attatch to the slides and body of my stronghold chuck are ruined from to much removal or excess force when tightening and now i cant get one of the jaws off. Due to damage on the hex screws my little wrench wont grab on and twist the screw off. I suppose the pun would be intended if i asked am i screwed???

Re: chuck slides

#2

Re: chuck slides

Walter Ahlgrim

>1 Start with a T shaped Allen wrench NOT an L shaped wrench

2 Do not use a china made wrench

3 If the wrench is not new shorten it on the grinder about 1/8 of an inch

4 At the hardware store get a bottle of �Screw Medic� this is sharp metal filings in cutting oil.

5 Secure chuck in a bench vice.

6 Clean hole with dental pick and compressed air.

7 Fill hole with �Screw Medic�.

8 Insert T wrench seat lightly with small hammer and remove screw.

9 Discard damaged screw.

Walta

Re: chuck slides

#3

Re: chuck slides

john lucas

>Excellent advice. I have usually been able to get them out by sharpening the end of the allen wrench. After you clean out the hole put the allen in and tap the top with a hammer to seat it really well. Then turn without tilting the wrench. I have also used Some CA glue to help in this situation. Just don't get any between the screw head and body.

Re: chuck slides

#4

Re: chuck slides

paul waddle

>Last resort,take to a machine shop and have them to discharge(spark it)machine it. They can take screw down to the root diameter and one can pick the reminants out..pw I guess you could also weld a rod to the top,but the former is preferred.

Re: chuck slides

#5

JL

Put it on a piece of thick plywood when you do..

JL

>this. It will really do interesting things to a flexible mat (DAMHIKT).

Re: chuck slides

#6

Excellent advice, Walta

Al Neighbors

>

Re: chuck slides

#7

Re: Put it on a piece of thick plywood when you do

Walter Ahlgrim

>I forgot the most important step!

10 buy a new chuck with every set of jaws you feel you must have.

JL did you skip step 5 :)

Walta

Re: chuck slides

#8

JL

Re: Put it on a piece of thick plywood when you do

JL

>When it happened to me, I took the insert out. I then put it on something soft. I have a hammer powered screw extractor. I whacked - so now I have a donut shaped "scar" in my mat.

I'd rather mess up a mat then mess up my chuck :). I have a couple of mats to spare.

Re: chuck slides

#9

Leo Van Der Loo

Re: chuck slides

Leo Van Der Loo

>Buy-beg-borrow-steal one of those impact drivers to get the screw out, then get a set of new screws, and only tighten the screws with one hand with the original T wrench.

Have fun and take care

Leo Van Der Loo


img

Re: chuck slides

#10

Re: chuck slides *LINK*

Dick Coers

>Make sure to get some antisieze for the next time.


copper antisieze