Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Washers for Sorby Threading?texturizing Tool

Posts

Washers for Sorby Threading?texturizing Tool

#1

Washers for Sorby Threading?texturizing Tool

bowlman

>OK, so I won a Sorby Threading/Texturizing Tool. Then I loaned it to a friend. When it was returned, I noticed a considerable amount of slop in the actual cutting implement. When I took it apart, I discovered that 2 of the 3 required washers were missing.

A trip to the local borg stores, with the remaining washer in hand, was fruitless. Yes, I could find the correct washer size (9mm if memory serves me), but the thickness is all wrong. The new washer is about 1.5 times as thick as the original.

Anyone know where I can get 2 or more replacement washers?

All help greatly appreciated.

Re: Washers for Sorby Threading?texturizing Tool

#2

Re: Washers for Sorby Threading?texturizing Tool

Dennis Yoder

>Dick, You might check a nut and bolt speciality store, machinest supply house, or use 2 replacements instead of the 3 original washers.

Ray Thompson may have some idea or contact the manufacturer directly. I checked Wholesale tool catalogue and they didn't have anything. Dennis Y

Re: Washers for Sorby Threading?texturizing Tool

#3

Re: Washers for Sorby Threading?texturizing Tool

John K Jordan

>I have on occasion filed washers to thickness.

JKJ

Re: Washers for Sorby Threading?texturizing Tool

#4

Re: Washers for Sorby Threading?texturizing Tool

Wilford Bickel

>I wanted some spares in case I dropped one in the shavings. I was able at the local owned lumber yard to find a pack of stainless steel washers the right thickness but too large in diameter. Just put a small bolt through the hole and held the edge against a gray wheeled grinder I use for metal working. Let them spin on the wheel till the diameter ground down to the correct size. Check for stainless washers the right thickness and then correct the diameter.

Re: Washers for Sorby Threading?texturizing Tool

#5

Are all the washers the same thickness?

Terry Quiram

>I realized that after reading this post that I am missing one. That would explain my difficulty using the tool.

Re: Washers for Sorby Threading?texturizing Tool

#6

Re: Are all the washers the same thickness?

don lewonczyk

>Use a forsner bit the right dia. and bore you a hole in some hardwood to hold the washer then put it on a belt sander with your table set at 90 degrees and grind away until you have the right thickness. Keep the piece moving back and forth on the table and turn it upside down and of course make sure your hardwood is perfectly square so you get even grinding. DonL

Re: Washers for Sorby Threading?texturizing Tool

#7

Re: Washers for Sorby Threading?texturizing Tool

Ed in Leaside

>My local borg has "spacer washers" which are much thinner than the regular washers.

Re: Washers for Sorby Threading?texturizing Tool

#8

Mike Mills

Re: Washers for Sorby Threading?texturizing Tool

Mike Mills

>You may want to try sending an email to...

sales@robert-sorby.co.uk

If they can't provide the washers they should at least be able to give you the thickness.

Mike