Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Help wanted

Posts

Help wanted

#1

Help wanted

Richard Jones

>OK, trying to do some peppermills, here's the problem: After drilling and turning the tenon on the cap, cap and base seem to turn on a different axis, i.e., they don't line up true when they are turned. So, the answer would be that either the tenon is not in the center of the cap or the hole in the base is not in the center, or something else that I'm not seeing. I found center of each part with the point of the skew prior to drilling. Hole in base is drilled from each end, not all the way through from one end.

I believe the lathe is set up properly, spec., spur center and cone center line up. Holes seem not to be drilled improperly, i.e., no vibration, no visual signal that they're off, etc. All parts seem to be running true, even after reversing. Difference is slight, but there nonetheless. And, this doesn't happen on every mill.

Can't figure this one out and it sure bugs me.............

Thanks for the help.

Rich

Re: Help wanted

#2

JL

Re: Help wanted

JL

>What I typically do is insert the tenon of the top of the peppermill into the base. I've got a 1/4" pointy cone jam chuck in my chuck that goes into the top of the peppermill and a live center in the tail stock that is in the bottom of the base. My top tenon is really close fitting.

I then "true up" the peppermill at relatively low speed and give it a final sanding.

Others may have their own fixes.

Re: Help wanted

#3

Re: Help wanted

Richard Jones

>JL,

Thanks for the tip about the cone jam chucks, I turned one to go into the base section, it did the trick. That way, you're relying on the holes for centering, not the tenons. Also, I drilled the small hole in the top from the top, not from the bottom. That centered that hole, everything ran fine. This certainly changes how I turn these, and for the better.

Will make the "pointy" jam chuck next time, that will allow me to true up the top by itself.

Again, thanks for the help.

Rich

Re: Help wanted

#4

JL

Re: Help wanted

JL

>Glad it worked for you.