Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Using Hot Melt Glue

Posts

Using Hot Melt Glue

#1

Using Hot Melt Glue

Richard R. Steussy

>One of the most-used tools in my shop is a 2-temp glue gun I got from Ace Hardware. Every time I mount a bowl blank, I put 4-5 drops of hot-melt evenly around the outside edge of the blank. I then bring the tailstock live-center forward in the circle center to press the bowl blank onto an MDF faceplate. Don't use too much hot-melt or you'll have to turn it off. If you use it sparingly, you can pry the faceplate off easily after you use the Forstner to get your chuck hole--the MDF will let loose. I find this preferable to screwing the blanks onto a metal face plate. And the sticky-back tape is useless. Vaughn Richmond from Australia did a session at the 2007 Utah Symposium in which he demonstrated this technique. Dick (bowlsaw.com)

Re: Using Hot Melt Glue

#2

Re: Using Hot Melt Glue

John K Jordan

>>And the sticky-back tape is useless

Just FYI, there is a way to use double-sided tape effectively. Starting with high quality tape (Woodcraft, et.al.), put a layer on the faceplate and burnish it well before removing the backing. Likewise, burnish a second layer onto the flattened bottom of the work. Remove the backing from both and press together. They will not come apart. A local turner uses this method for large chunks, 16" or so in diameter.

JKJ

Re: Using Hot Melt Glue

#3

Re: Using Hot Melt Glue

Ron McKinley

>I've never had any luck with hot melt glue and have not tried the tape but I have a friend that uses tape routinely for small pieces using wooden faceplates....Ron

Re: Using Hot Melt Glue

#4

No Hot Glue in My shop

jake Niedling

>I have just never had a need to use it. Almost everything I do starts between centers, a small tenon is made and then mounted in a scroll chuck or if it is small the tenon is glued into a waste block mounted in the scroll chuck. Of course, I could not live without my

CA glue.

Re: Using Hot Melt Glue

#5

JL

Yellow glue with a paper separation layer

JL

>works well for me. I use this method to make 1/2 turnings for furniture fronts. Glue up two boards with a brown paper layer between them. Turn the spindle and whack with a chisel to separate when done.

Re: Using Hot Melt Glue

#6

Re: Using Hot Melt Glue

Bill Howatt

>IMO, the usefulness of various methods is highly dependent on how dry the blank is. If it is wet then CA glue is the best and even then the joint should only be used for about a day since the wood will be shrinking and CA joints are brittle.

I agree hot glue is good but not if it is the light duty craft stuff. As far as double-sided tape goes, I've had to turn pieces off the faceplate with it. Secret is good quality tape and to press the pieces together using a vise or tailstock for at least several minutes before using. Just sticking it on and hand pushing the pieces for a couple of seconds doesn't do the same job.

Bill

Re: Using Hot Melt Glue

#7

Denis Putland

Re: I have had good success

Denis Putland

>using Hot Melt glue. But since I got my scroll chuck I now start almost all my turnings between centres. You have so much room for making adjustments when starting between centres.

I can not for the life of see why one would use a face plate unless you absolutely have to.

The secret for a good bond with holt melt glue is to preheat both pieces with a heat gun. I have rough turned very wet green 16 inch blanks using hot glue as bond.

Denis