Home made round skew
Terry Quiram
>This is 3/8 dia. I haven't had a chance to use it yet. The brass is a left over from a back scratcher kit and the handle is Kingwood. Wally Dickerman you inspired me to bead the handle.
Knowledge You Can Build On — Est. 1998
Home made round skew
Terry Quiram
>This is 3/8 dia. I haven't had a chance to use it yet. The brass is a left over from a back scratcher kit and the handle is Kingwood. Wally Dickerman you inspired me to bead the handle.
Handle close up
Terry Quiram
>
That kingwood looks a lot ...
Ed Moore in SW Virginia
>like tulipwood to me. In any case, nice job.
Ed
Re: Home made round skew
keith zimmerman, Normal IL
>Is this the skew I ground for you?
Re: Handle close up
Michael Stafford
>Looks nice, Terry. I have a new appreciation for the round skew since I had some lessons with Ed Moore.
Looks like tulipwood to me also.
Re: Home made round skew
GalenV in Iowa
>Terry,
What did you use for the 3/8" steel?
Angle of grinds?
Making your own tools is sure an lot cheaper for me and you end up with a very good feeling when they work.
Hate to pay a lot for a tool just to try it but I got lucky with Thompson tools and I am VERY happy with them. At least I can say I made the handles!
That much beading will take me a long while to do and not screw up.
Galen
Re: Home made round skew
charlie belden
>If you ground that puppy's bevels back a bit more - and put a slight curve in the bevels so the long point won't catch as easily - but still be there for long point cuts . . .
(my personal bias about skews showing?)
Nice tool - and I'm sure you'll discover uses you haven't thought of - yet.
Re: Home made round skew
john lucas
>Nice looking tool. I have a 3/8" and I think that is about as thick as a skew should go if it's a round bar. The shoulders of the bevel get in the way for some cuts. I'm really happy with my 1/4" round skew and I have a 3/8" spade bit that has a 1/4" shaft that I like.
Re: Handle close up
Terry Quiram
>I think you guys are correct that it is Tulip and not Kingwood.
Keith Yes it is the one you ground for me.
You made a good looking tool Terry.
keith zimmerman, Normal IL
>