Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Home made faceplates

Posts

Home made faceplates

#1

Home made faceplates

Jerry Klug

>I would like to find a reasonable source for 1-1/4 x 8 nylon lock nuts to use for the thread of a wood face plate. I can find the 1" nuts but the 1-1/4" are harder to find and one source was ridiculously expensive. An aluminum face plateplate was less.

Re: Home made faceplates

#2

Re: Home made faceplates

Randy Gleckler

>The Best place I found when looking was Grainger. I think it was a 4 or 5 pack for like $20

Re: Home made faceplates

#3

Re: Home made faceplates *LINK*

Cyril Griesbach

>Jerry, why not just get a spindle tap and make the whole thing out of wood? I've had good luck doing this for lots of things besides just faceplates.


Spindle Taps

Re: Home made faceplates

#4

Rob Wallace

Re: Home made faceplates

Rob Wallace

>Randy:

As I thought, the nylon-insert lock nuts you refer to at Grainger (or pretty much everywhere else for that matter) are 1-1/4" x SEVEN threads per inch - NOT EIGHT threads per inch. These will not likely work on standard 1-1/4 x 8 tpi lathe spindles.

I have used the 1" x 8 tpi nylon-insert locknuts on lathes with this spindle threading, but I don't think you will find a source for the 1-1/4" nuts with the correct threading unless they are made in a cu$tom order.

Rob Wallace

Re: Home made faceplates

#5

Re: Home made faceplates *LINK*

GalenV in Iowa

>Rob

Grainger does have heavy hex 1 1/4-8 and I would think you could turn out some thread if you still need the recess for 1 1/4-8 spindle.

Use the reg nut picture on Grainger web site and in pull downs put in the thred and it should bring up the heavy hex. The link I tired to post does not work right.

They are like $24 for package of 5.

Fastenal has the lock nuts but about $32 list price each!

Galen


http://www.grainger.com/Grainger/wwg/guideBrowse.shtml

Re: Home made faceplates

#6

Re: Home made faceplates

Bill McWhirter

>Our local Fastenal store has 1-1/4" steel nuts in stock on the shelf for around $4.( I could not find in the on-line catalog) I purchased a couple along with 1-1/2" washers. After drilling 3 holes in the washers, I welded the washer on to the nuts and had some quite adequate faceplates for around $5 each. My PM 3520 spindle is longer that the nut so I use another washer for the nut to jam against.