Jamieson boring rig - - construction update
Pete in Holland, MI
>Hey all -
Thanks for all the feedback last weekend, even from "the man" himself!
By the end of this weekend, I should have the outer tool rest completed. I also have the tool handle all bent up and ready for a boring bar, which is also this weekend's project.
I have seen on various sites that some people put the 3/16" tool bit directly in the boring bar, either straight, 45 or 90 degrees to center-line. I also see on Lyle's site he has a 3/8" rotatable tool holder for the boring bar.
Questions:
1) Is Lyle's rotatable tool holder what will be used for roughing and finish turning, or is a tool bit directly in the boring bar better for rough turning? Or is it a luxury & not needed? Is his the one to use or you having better success with other designs?
2) Is the steel-on-steel an adequate surface for the handle and outer tool rest to bear on, or is it better/worse to have a dense plastic (nylon or UHMW) on the parallel bars of the outer tool rest? Would assume the plastics would make the system a bit quieter too ?
Anxiously awaiting hearing about your experiences !
Pete





