Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

A question

Posts

A question

#1

A question

jared

>I just turned an ash bowl down to its final shape and thickness, the roughout had been drying for some time as I was kind of afraid to go further with it but on the other hand I was itching to finish it as I knew it had a lot of potential. I have not done any sanding on it yet. There is a really nice bark inclusion, part of it looks very thin and fragile, on one side of it and a large area that is kind of punky. I have used ca glue on smaller areas like this on other bowls but there is too much of it on this bowl. I seem to have read of soaking a bowl in a mix of half water and half white glue to reinforce and harden areas like this. How well does this work? Will the glue residue affect the final finish? I use a lacquer sealer with and oil varnish mix for the final finish. I just dont want to wreck this thing as I have gotten it this far without damaging it. Thanks in advance Jared

Re: A question

#2

Re: A question

John K Jordan

>Jared,

I haven't tried white glue, but I have used multiple coats of sanding sealer to toughen up punky areas on spalted wood.

JKJ

Re: A question

#3

Re: A question

john lucas

>Ditto what John said. I use thinned lacquer to strengthen punky areas.

Re: A question

#4

Re: A question

David Walser

>I've used the thinned down yellow glue approach with some success in the past. However, I don't think I'd try in on your bowl. IIRC, I've always applied the glue before I was through machining. As anyone who's experienced squeeze out on a joint knows, yellow glue will affect the ability of the wood to take a finish. Taking an additional cut or two leaves a uniform surface that prevents the final finish from being splotchy. Since you've already turned the bowl down to its final size, I'd be concerned that sanding would would not leave a uniform surface and might give you a splotchy finish.

You might consider MinWax's Wood Hardener. You should be able to apply Wood Hardener to the entire piece, let it soak in, and end up with a uniform surface for finishing purposes.

Good luck!