Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Home Made Turning Tool

Posts

Home Made Turning Tool

#1

Home Made Turning Tool

Tomm

>I made a turning tool from a square shaft screwdriver. I do not have the handle on the tool so it would be easy to heat treat if needed. Would heat treating be necessary? I ruined an inexpensive hacksaw blade trying to cut through the blade so I think the steel is harder than cold rolled material. Thanks for your thoughts.

Re: Home Made Turning Tool

#2

Re: Home Made Turning Tool

Tomm

>Sorry for the mistake spelling homemade. It really shows when it is in a title.

Re: Home Made Turning Tool

#3

Re: Homemade Turning Tool 

Tomm

>

Re: Home Made Turning Tool

#4

Re: Home Made Turning Tool

Paul Waddle

>Hey Tom,we all make scraping tools from screwdrivers... I would take a little more time and epoxy a metal turning bit into to socket screw driver. No criticism is implied,you are probably more adept at turning then I am.pw

Re: Home Made Turning Tool

#5

Re:If it seems to be that hard, I wouldn't .....

JamieD

>... try to improve it and possibly make it worse rather than better. Screwdriver steel comes in every degree of hardness, and the tools we make from them seem to work pretty well as they are without further modifications in steel quality.

Re: Home Made Turning Tool

#6

Re: Home Made Turning Tool

john lucas

>You don't need to go through the heat treating. Just use it and resharpen often. It didn't cost much. You probably don't know what kind of metal it is so heat treating would be guesswork anyway. I've heat treated screwdrivers and think they were better but I really didn't have a good basis for that assumption.