Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Paul Waddle's threading jig pictures *LINK*

Posts

Paul Waddle's threading jig pictures *LINK*

#1

Paul Waddle's threading jig pictures *LINK*

John K Jordan

>Attached are Paul Waddle's pictures as mentioned in the thread: Bonnie Klein threading jig, link below.

http://www.woodcentral.com/cgi-bin/turning3.pl?frames;read=199788#199788

Paul Waddle -- Tuesday, 27 January 2009, at 8:38 a.m.

I made my own thread jig,wish I could post pictures-tried,but old brain just won't function.Email me if you like. I took some boxes I made and an 8x10 picture of my jig to the recent LAW club and about 10 ten people said they were going to make one similar.

Paul will have to provide any comments - I'm just the photo-posting guy!

JKJ


img

threading thread

Re: Paul Waddle's threading jig pictures *LINK*

#2

Paul, can you explain how

Al Neighbors

>you turn the piece in the chuck?

This looks like a nice threading jig. I wonder how I might come up with something like this...

.....now where did I put that old cross slide vise....????

Re: Paul Waddle's threading jig pictures *LINK*

#3

Re: Paul, can you explain how

Paul Waddle

>Sure can and be glad to explain . The cross vise provides the off set or dimensional difference for the cutter,& hold the cutter while it revolves. The rear crank on the vise is just to get it in "range" lenght wise for the chuck/box to turn into. A slave nut on the end of the thread jig,determines the tpi. With my jig you can change thread pitch by changing a driver stud and nut combo. Any Nut and bolt- sae or metric that you can buy at the hdw store, will work. I've made 10,14,16, and 20tpi. This is powerful but maybe not too useful since most prefer 16 tpi. Its no gimmic and I claim only a little credit-its an adaptation of the ancient ornimental lathe. For futher dicussion,email me. I do tend to be wordy..pw