Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Buffing System Tutorial Addendum

Posts

Buffing System Tutorial Addendum

#1

Buffing System Tutorial Addendum

Allen Neighbors

>For those of you that got my Buffing System Tutorial:

Thanks to Dennis Yoder, here is a link to the extended mandrels for electric motors. They call them Shaft Adapters.

They cost 10.99 for the 6"extended adapter for the 1/2" and 5/8" motor shafts, and 13.99 for the adapter for a 3/4" shaft.

These will put your buffing wheels farther out from the motor, and if you mount your motor on a table corner, and get (or make) 8" wheels, you can buff large bowls that are pretty deep.


img

Re: Buffing System Tutorial Addendum

#2

Whoops!! Here's the link. :(  *LINK*

Allen Neighbors

>


http://www.caswellplating.com/buffs/longsa.htm

Re: Buffing System Tutorial Addendum

#3

Steven Antonucci

Cheaper way to make them

Steve Antonucci

>I turn mine out of scrap wood to be held in chuck jaws on the lathe. This happens to be a wire wheel, but I also have many buffing wheels on mandrels.

If you take a few minutes to turn them nicely, the center up pretty accurately (I don't thing that really matters with a buffing wheel, but I could be wrong?) No reason you couldn't make on for the little screw on buffing balls...

Steve

P.S. I have one for each wheel, and I write on the side of the wheel what it is used for to keep from cross contaminating wood/metal, white/red rouge, wax, etc...


img

Re: Buffing System Tutorial Addendum

#4

Re: Cheaper way to make them

Allen Neighbors

>You're right, it doesn't take an extra motor when you use your lathe, so it is cheaper. I do have some individual buffers made for when I'm travelling, to use on my Little Vic. The only thing wrong with using them on my large lathe, is that the chuck gets in the way, when I'm buffing a larger piece. Also, with my little lathe, I can't re-buff some of the larger pieces that might need it when I get to a craft show.

Re: Buffing System Tutorial Addendum

#5

Steven Antonucci

I make them longer too

Steve Antonucci

>Just happens that I have a picture of a short one posted, but I also make them much longer to get past the chuck being in the way...

I meant no cost for the mandrels too, not the buffer. I turn them out of whatever I have laying around when I get a new wheel. I have found that they run much better with big washers in the middle like you would have with a grinding wheel. I have a box of them from my FIL legacy cleanout...

S

Re: Buffing System Tutorial Addendum

#6

Dick Hines

Re: Buffing System Tutorial Addendum

Dick Hines

>Woodturners catalog has a long buffing adaper in 5 thread sizes. They are $29.99. I have used one for years and love it. It is 8" long and is made of aluminum.

Re: Buffing System Tutorial Addendum

#7

Re: I make them longer too

Jerry McCaffrey

>Steve

Looks like a good idea. I hate all the lint and fuzz from buffing so I use the long mandrels on a used motor that I clamp to the deck railing and then my "lint machine" is outside. There are usually a few good days for buffing even in the winter.

Jerry