Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

pen turning using sapwood and heartwood

Posts

pen turning using sapwood and heartwood

#1

pen turning using sapwood and heartwood

marc rosen

>Hey All,

I have been turning pens for a few months now and last week I tried a piece of African black wood that was 50% sapwood. All looked fine after shaping but when I sanded it I noticed that I had imparted a lot of dark dust into the grain of the sapwood. It did not look bad but I was disappointed that I did not have the clean yellow field that existed in the pre-sanded mode. I thought about trying to sand that section with the grain but decided against it and finished the pen as is.

Is this something that I will always encounter when sanding heart wood and sap wood (or light and dark woodstogether, regardless of their origin) on a lathe? Any preparations or techniques to minimize this effect? Thanks in advance for any suggestions.

Marc

Re: pen turning using sapwood and heartwood

#2

Re: pen turning using sapwood and heartwood

John Weeks

>Marc - I've just recently aquired the Beal Buffing system. One of my favorite designs with pens is a celtic knot with contrasting light/dark woods. I never had this problem when sanding/polishing with micro-mesh, but I noticed that buffing with tripoli definitly carried dark material into the lighter wood.

So I'm also wondering if there is a solution.

Re: pen turning using sapwood and heartwood

#3

Re: pen turning using sapwood and heartwood

GalenV

>I ask a similar question on Dec 28 on segmental turning.

I was making glue up for small boxes from bloodwood and maple. Ended up with pink maple.

Some suggestions were to start with sanding sealer before first sanding and try to vac the dust and not wet down between sandings.

Spray the sealer to keep from brushing colors together.

Sanding sealer between grits to try and keep dark dust from getting in pores of maple.

My second such box I tried the methods and although better still a little pink tint.

I did a walnut and maple box next and it was a little better.

I have watch video on segmental turning and they just show power sanding and not muck what is done if anything between grits.

I have not had a chance to get a suggested book on segmental turning to see if they actually put in writing how they keep colors seperate.

I'll see what you may get for added info.

Galen

Re: pen turning using sapwood and heartwood

#4

Re: pen turning using sapwood and heartwood

marc rosen

>Hey Galen, John,

Thanks for your comments. I will try the micro-mesh mentioned on the next one I turn and look back in the archives for the bloodwood/maple posts.

Take care and keep having fun turning.

Marc

Re: pen turning using sapwood and heartwood

#5

Re: pen turning using sapwood and heartwood

Bill Stehman

>Avoid coarse sandpaper, start with no more than 180 and use high pressure air while sanding. When finished use more air cleaning all pores then use a tack cloth to clean all remaining particles.

Spray on a sealer do not wipe. This method works with bloodwood / padauk and holly or soft maple and with all ebony's and white woods.