Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Tip

Posts

Tip

#1

Tip

John Veerkamp, Western Mo

>This should be so elementary as to not need stating, but something I just did made a world of difference. I was having trouble with my Talon jaws holding, especially in expansion mode. in examining the jaws I observed many little nicks and the edges were rounded over. I've been using these jaws for about 5 years now and they've taken a beating. So I closed the jaws up and turned on the lathe at about 300 rpm. Holding a mill file flat against the face of the jaws took only a few seconds to restore a flat face and crisp egdes. Al light touch with 220 grit sandpaper to remove the edge burs and they're as good as new.

Just thought I'd pass this one on for other slow learners like me. Another maintenance item.

John

Re: Tip

#2

Thanks John!

Gary in Zirconia, NC

>

Re: Tip

#3

Re: Thanks John!

Ken

>Sounds like a good idea,after all there are new folks that will appreciate all these little tips that folks like you post