yikes, the Woodsmith podcast #7 *LINK*
John K Jordan
>After watching the sharpening video by Brian Simmons (mentioned earlier), I decided to watch his earlier bowl turning video.
Almost immediately, he teaches a very dangerous technique - how to cut a small log on the bandsaw CROSSWISE, starting by cutting through the unsupported round leading edge of the log section. Cutting unsupported wood with a bandsaw is a disaster waiting to happen and can result in bent blade, damaged bandsaw, and missing fingers. I was surprised to see this in a training video for beginners. Ack!
I'm sure an observer can point out unsafe things in my practices as well (and perhaps yours), but this one seems blatant to me.
For those unfamiliar with the hazard, the blade can catch the front of the rounded edge and force it downward, rotating the log section forward and forcing wood violently into the blade. If you want to experience this for yourself, do it on someone else's bandsaw (not mine) and keep your hands well out of the way!
In the case of the video, the mass (and inertia) of the relatively long log section doubtlessly worked in Brian's favor, as did the slowness of his cut and the softness of the wood. A v-block, but while this works great to cut through a dowel or small blank turned round (say for a box), but this is not always reasonable for a large or uneven log section. It can be done safely by wedging the log section in the front AND the back. Some people hot glue wedges to the log, but I find it sufficient to jam appropriate wedges under the log. I can usually find suitable wedges in the scrap box, but I'll cut them to fit if needed.
A few minutes after the bandsaw segment he describes getting long shavings from "shear scraping", defining the term, it appears, creatively. I think I'll wait and watch the rest tomorrow.
JKJ
Podcast #7



