Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Norfolk Island Pine

Posts

Norfolk Island Pine

#1

Norfolk Island Pine

eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---

>I turned some of this wood today for the first time -- a vase shape about nine inches deep and six inches in diameter at the largest point. It turned like butter; but I may have ruined the piece using the usual finishing method that I use. I sanded well and applied some shellac ,then applied some Velvit oil. But it now has a kind of grey, dirty look. It just looks dead and uninteresting to me. What did I do wrong?

Re: Norfolk Island Pine

#2

Bill Blasic

Re: Norfolk Island Pine

Bill Blasic

>Hopefully David Chung will answer your question as he has been very helpful to me with questions about Norfolk Island Pine. He can give you his formula for the oil soak that the piece needs.

Re: Norfolk Island Pine

#3

Re: Norfolk Island Pine

Barbara Gill, Remlik VA

>I use Velvit Oil on NIP with good results. The oil should be used on raw wood so the penetration is maximized. I put several coats on followed by buffing when cured.

Re: Norfolk Island Pine

#4

Re: Norfolk Island Pine

Ken Oakley-Sunny St. Cloud, Fla.

>I have obtained a few nice size logs of NIP. What is the best way to cut blanks from them? Do I cut cross grain or with the grain?

Re: Norfolk Island Pine

#5

Re: Norfolk Island Pine

Barbara Gill, Remlik VA

>If you are cutting pen blanks, with the grain. If you are cutting for hollow forms, across the grain, leaving the log whole.

Re: Norfolk Island Pine

#6

Re: Norfolk Island Pine

Ken Oakley-Sunny St. Cloud, Fla.

>Thank you. Pretty much what I figured.

Re: Norfolk Island Pine

#7

Re: Norfolk Island Pine

eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---

>Perhaps David Chung will respond. Thanks.