Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Wine/Beer safe Finish

Posts

Wine/Beer safe Finish

#1

Wine/Beer safe Finish

dan oliphant

>I have been asked to make two sets of ceremonial goblets that will be used during wedding prodeedings. One set will be used for the bride and groom toast, containing Champaign (one goblet) beer in the other.

The other set will only be used with champaign.

I am thinking of using Ash because one couple wants the wood to be light in color and uniform, the other couple wants the goblets dyed black, but able to see the wood grain clearly.

Now my question, would using a lacquer sanding sealer followed by four or five sprayed coats of lacquer, then buffed, be compatable (and safe) with beer and champaign? Should I use another finish scheme altogether?

Re: Wine/Beer safe Finish

#2

Re: Wine/Beer safe Finish

Greg Haugen

>Dan,

The mentioned method of finish would work for awhile however lacquer does break down to alcohol, and it would take a long time to cure to be safe to be used. This has been asked several times and a common answer is using CA glue as the finish, or turn a wood stem for a glass insert would be an option. CA withstands the effect alcohol pretty well. If enough coats are applied, an open pore wood like Ash would be ok, a finer grained wood would be better, in my opinion, over the life of the pieces.

I'm sure more will chime in with tips.

Greg H.

Re: Wine/Beer safe Finish

#3

JL

Re: Wine/Beer safe Finish

JL

>I wouldn't use an open pore wood like ash. Maple would be my preference. As far as a finish - I played around with chalices. I ended up using wax for one (Carnuba) because it was hard, renewable and "food safe". I also used CA and 2 part clear epoxy. The 2 part clear epoxy was the toughest finish.

I sort of had a preference for the Carnuba. It was the easiest to apply.

Re: Wine/Beer safe Finish

#4

Re: Wine/Beer safe Finish

Ralph

>Dan

I tend to prefer Envirotex for this type of application

Re: Wine/Beer safe Finish

#5

Re: Wine/Beer safe Finish

dan oliphant

>Ralph, have you used Envirotex on anything other than a flat surface? if yes, then would you explain how you maintained a uniform finish?

Re: Wine/Beer safe Finish

#6

Re: Wine/Beer safe Finish

Alan C. Foster

>I've had good luck with water-based acrylic. I used a Minwax product; others should work as well. Friends who had previously complained about lacquer flavoring the drink (both alcoholic and non-) found the water-based product acceptable.

Ace

Re: Wine/Beer safe Finish

#7

Re: Wine/Beer safe Finish

Carole Valentine

>Same here. I used the WB acrylic (about 3 coats) on a wine goblet for my nephew and it has held up very well.

Re: Wine/Beer safe Finish

#8

Re: Wine/Beer safe Finish

Ralph

>I just "paint" it on with a small brush. I feel I get a thick enough coat that way

Re: Wine/Beer safe Finish

#9

Re: Wine/Beer safe Finish

dan oliphant

>Thank you all for the great input. I believe the water based acrlic finish will do the trick. Thanks again for your input.