Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Wax on blank

Posts

Wax on blank

#1

Wax on blank

Hal Smith

>I have a blank for turning a bowl that is coated with wax. Hate to display my ignorance, but what's the best way to remove it? I assume that it would gum up my tools if I tried to turn without removing the wax. Thanks for any help. Hal

Re: Wax on blank

#2

Re: Wax on blank

Jim Pugh, Elyria, OH

>Hal, don't worry about the wax. You'll cut it all off.

Re: Wax on blank

#3

Ric Taylor

Re: Wax on blank

Ric Taylor

>Hal,

Don't worry about it, it won't gum up your tools. Just go ahead and mount the blank on your lathe and start turning. All of the wax will disappear into the shavings pile on the floor. Just ignore the wax as though it wasn't there.

Ric

Re: Wax on blank

#4

Re: Wax on blank

Barry Turner

>Just turn it away. I've never had a problem with it gumming up tools.

Re: Wax on blank

#5

Re:Unless it's on the spikes of a .......

Jamie D

>.....natural edge burl, and then a stiff nylon brush will remove the remainder. If it's a real pain, use a hairdryer to soften it up, then the nylon bristle brush will do the trick.

Re: Wax on blank

#6

Re: Wax on blank

John K Jordan

>The only thing I'd keep in mind is unless it is pretty old a waxed blank may be a wet blank and may need to be handled like green wood.

Re: Wax on blank

#7

Re:Unless it's on the spikes of a .......

john lucas

>Mineral spirits and a brush will get it off. Wear goggles or glasses.

Re: Wax on blank

#8

Ellis Walentine

One small warning

Ellis Walentine

>Watch out that you don't slip on the waxy shavings. DAMHIKT :-)

Ellis

Re: Wax on blank

#9

footing

John K Jordan

>Along with that, don't ever apply anchorseal to a bunch of blanks in an area where you will stand and walk. Spreading the dried drips with my feet lubricated the concrete floor with a wonderfully slippery waxy film. Now I need to keep the floor covered with six inches of shavings or sprinkle cat litter or put down more rubber mats or even [gasp] clean the floor.

Re: Wax on blank

#10

Re: Wax on blank

Dennis Barley

>Hal:

When I have a waxed blank that I don't plan on turning immediately and want to dry, I (gently) hold the waxed edges to the edge of my band saw blade and scrape off the wax. Hope this helps.

Dennis

Re: Wax on blank

#11

Re: Wax on blank

Hal Smith

>Many thanks to all.

Re: Wax on blank

#12

HERETIC!!!!

Steven Kubien

>Clean the floor?!?!?! Are you mad? I thought that obscene language/behaviour was frowned about here on Ellis Island.

Steve Kubien