Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Salt Shaker and Peppermill questions?

Posts

Salt Shaker and Peppermill questions?

#1

JL

Salt Shaker and Peppermill questions?

JL

>I've made a couple of sets - and they were okay. Anyway - it's getting near Xmas time, so I figured I'd make a couple of sets as presents again.

OK - I've got the Woodcraft (6") and Rockler (10") mechanisms already on hand (the metal sort, not the fancier type). The directions say that I should have a 1 5/8" hole for ~1/2". What sort of wall thickness should I shoot for? My last sets, I went for ~ 1/4" or so in this area. I was doing the short mechanisms, and I thought they looked a bit chunky.

What is a reasonable size (diameter) for the starting blank? I've got some nice chunks of maple (2 1/2" up to 3 1/2" thick). I also have some thinner cherry blanks (~1 7/8" up to 2 1/2" thick).

TIA.

Re: Salt Shaker and Peppermill questions?

#2

Re: Salt Shaker and Peppermill questions?

Chuck Engstrom

>Hi JL -- I'm just starting out on salt/pepper mills myself so I don't have much experience yet, but I'll jump in and suggest that the thickness of the wall is less important than how the mill ends up looking with whatever exterior bottom diameter you go with.

I'm using the typical metal mechanism that calls for a 1-5/8" bottom bore, and my two 6" mills ended up at about 2-1/8 OD" on the bottom. A little more might look better, and I plan to turn some scrap wood into peppermill shapes just to get a good grip on that without wasting good stuff.

Most of the instructions I've seen for pepper mill sets say that blanks should be 2-1/4" minimum, though mine were just a bit less than that to use up scrap wood. Taller mills might want a little more. Don't forget that how it's going to feel in a user's hands should play into your design.

Best--

Chuck Engstrom

Re: Salt Shaker and Peppermill questions?

#3

Re: Salt Shaker and Peppermill questions?

Jorge Castaneda ~ Downeast Maine

>Jerome,

I've made a few, it is better to start with enough meat to spare, and then shape it and if you feel it still too thick, you can shave some more, I did a couple that were too thin, almost see thru at the bottom of some beads, ended up making new bodies with more meat.

I also like the looks of a flared bell at the bottom. If I make some more I will start with 3" stock.

$0.02

Jorge