Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

BowlSaw

Posts

BowlSaw

#1

BowlSaw

Kevin Jones

>After reading an article in More Woodturning magazine about Richard Steussy's BowlSaw I contacted Richard and he sent one out to me right away. The following is the e-mail I sent back to him within hours of working with this tool.

Hello Dick,

The BowlSaw arrived late yesterday and I had to wait till today to try it out. What a wonderful little tool!!! It performed just as easily as you said it would. Following the instructions very carefully and using a parting tool to cut the groove, I pulled these two bowls out of a six inch diameter piece of walnut. The wood is still a little wet and I have placed them in paper bags now to dry and finish later.

Remember, I told you I�m a real rookie at bowl turning. Including these two I could count all the bowls I�ve turned on both hands and still have fingers left over. So, for what my opinion is worth, I think you have a real winner here. If I can use this tool and succeed on the very first shot, anyone can. I�m looking forward to getting two for the price of one on a whole lot more bowl blanks.

Once again, thanks for a wonderful little tool.

Kevin Jones

Ft. Myers, Florida