Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Newbie needs start-up advice

Posts

Newbie needs start-up advice

#1

Newbie needs start-up advice

Brian in SLO

>Well, I finally took the leap into turning! I'm normally a Normite over on the other board. I never thought I'd get into turning for fear of it creating a whole new monster but I came across a good deal on a Delta Midi-lathe on Craigslist and now here I am.

All I have at the moment is the basic lathe with the basic live center it comes with. I am interested in making pens (isn't everybody?) and maybe ornaments, small bowls and the occasional small misc. thing I need for whatever. So, what should I be looking for to get started? What's a decent but inexpensive set of knives to start with? I'm guessing I'm now in need of a grinder for sharpening. What else?

Any help or suggestions anyone may have is always appreciated. Also, if anyone has any starter tools they don't need anymore...I'm in the market.

Thanks everyone!

See what I meant, the monster has been created! ;)

Re: Newbie needs start-up advice

#2

Re: Newbie needs start-up advice

nick

>Yah, I see. My only advice is devote a lot of time and money or go back to Norm. Get some lessons. I didn't when I started and I've spent about ten years learning a few basic skills.

Re: Newbie needs start-up advice

#3

Re: Newbie needs start-up advice

John K Jordan

>You might look for a turning club in your area. There are usually lots of demos, turned pieces to see, and people to talk to - some beginners, some experts. A turning course or two is a great way to start - you get guided instruction in both tool use and how to proceed. Our Woodcraft store offers beginner courses in pen turning, bowl making, ornaments, and more.

The basic needs are a good grinder (slow-speed grinder is commonly used), perhaps a grinding jig like the Oneway Wolverine, a 4-jaw chuck, and a few tools. Misc: good sandpaper, dust mask, finishing supplies. Common starting tools are a roughing gouge, spindle/detail gouge, bowl gouge, skew chisel, and parting tool. Add a scraper or two. Hollowing ornaments may require a special mini hollowing tool. Go wild after that. A bandsaw is a useful accessory but perhaps a normite will have that.

Don't buy carbon steel turning tools. Make sure they are HSS. I started with a set of inexpensive HSS tools from Sears and still use most of them today. Doug Thompson Tools has arguably some of the best around - they seem to hold an edge better than most. There are many other good brands - Sorby, Crown, etc. You will pay from $30-$60+ for good individual tools with a set often discounted. Sometimes places like Woodcraft will discount a set of tools if you take one of their turning courses.

JKJ

Re: Newbie needs start-up advice

#4

Re: Newbie needs start-up advice

Don at Central Illinois

>Depending on what you want to accomplish, watch out for the Sears set. Most 'set's are for spindle turning. If that's what you want, pens for example, OK, but if you want to do bowls, hollowforms, vases, etc. you will need some bowl gouges and they normally don't come in a set. At least I don't remember finding a 'set' for bowls. Good luck and welcome to the slippery slope of turning. There is no turning back.

Re: Newbie needs start-up advice

#5

Re: Newbie needs start-up advice

Lynn from Port Townsend

>For turning tools, consider Benjamin's Best from Penn State Industries. They are high speed steel (HSS) and very reasonable. These make very good starting tools.