Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

CA Stitches - have you done it?

Posts

CA Stitches - have you done it?

#1

CA Stitches - have you done it?

Jim K i nTrappe PA

>Last weekend I sliced my finger (non turning stupidity). It was not serious, but deep. When I decided it needed stitches, I thought Super Glue! The problem was that it needed stitches because it was deep and bloody. If I kept a paper towel on it and applied compression, no problem. If I stopped, it started bleeding a lot. I couldn't figure out how I would put super glue on this mess, so I went out and got a couple stitches.

Question - how should I have put on CA? Over blood? Tourniquet? If you've done it, what was your method?

Thanks,

Jim

Re: CA Stitches - have you done it?

#2

Re: CA Stitches - have you done it?

HeatherA in AK

>My turning instructor, retired gastro-enterologist, split his lip open and used CA to fix it. He said the pain/burning was terrible but it looks good now. I'm not sure how he actually did it, I would imagine that it was bleeding alot also. Wasn't CA glue originally used my medics in battle situations?

Heather

Re: CA Stitches - have you done it?

#3

Re: CA Stitches - have you done it?

Texian

>Jim,

Since compression with the paper towel was observed to be successful, I would have just wrapped the paper towel with about three layers of masking tape. The problem is to apply just enough compression to control bleeding without completely restricting circulation. Inspect the wound after a few hours to determine subsequent treatment.

Probably you did exactly the right thing.

Re: CA Stitches - have you done it?

#4

Re: CA Stitches - have you done it?

Brian Simmons, Heflin, AL

>I have used it on many occasions. It works best on wound you can dry and then close to prevent the flow of blood. Sometimes the blood will bubble through the CA but it will usually hold. The disadvantage of CA is that it will not retain its adhesion while healing. Constant reapplication is required (every day). I have heard it is used in emergency rooms but only to hold wounds closed temporarily.

Ca is very useful for winter time cracked hands, drop CA in the cracks and the pain is gone. Reapply as needed.

Re: CA Stitches - have you done it?

#5

Re: CA Stitches - have you done it?

Fog Tanner

>CA was originally developed for use in Nam. You could pour it over the wound and seal all the blood vessels and then mop it up.

I have used it since the late 70s instead of bandaids. I have a couple of pieces of flesh I have glued back in, not just cuts. I wash the cut off with clean water and in the case of the gouged out flesh - push it back in place and hit it with the CA. If it is a cut, same thing wash it out and pour on the glue. I wait a minute to make sure it is glued and then get on with the program.

Main thing is to make sure it is clean before sealing up the wound. The glue will dissolve in three days from body oils, but by that time the skin is already stitching itself back together.

If you use a bandaid, make sure any excess glue is wiped off before putting it on. I peeled a section of flesh out of finger at a race one time, we washed it and replaced the skin and then hit it with the superglue. One of the ladies handed us a bandaid and in the rush, wraped it around the finger. Needless to say, the bandaid was on there for three days, by that time it was pretty ragged and worn away in spots - but the CA did its job.

Re: CA Stitches - have you done it?

#6

Re: CA Stitches - have you done it?

Steve Russell

>Hello,

Monofunctional 2-cyanoacrylates were first discovered in 1942 during World War II, but were not patented until 1949. In 1951, scientists at Eastman Kodak were working on thermal polymerisation and accidentally discovered the rapid ambient-temperature cure and superior adhesion properties of cyanoacrylates.

While working on a freshly prepared monomer, the Kodak scientists discovered that the glass prisms of their refractometer had become tightly bonded. Extensive research thereafter found many different types of substrates bonded in a similar tenacious manner. The first viable production process did not evolve until 1954. Subsequently in 1958, Eastman #910 debuted, the first commercially available CA product.

Specially prepared cyanoacrylate formulas are used in numerous medical procedures, including heart surgery, eye surgery, ear surgery, cerebrospinal fluid leak repair, skin closure, emergency wound closure assistance in military battlefield conditions (Vietnam saw widespread use by MASH units) and numerous other areas.

However, the common industrial types of cyanoacrylates are not the same formulas used in the medical profession. Typical industrial cyanoacrylates are usually ethyl, or methyl based esters and can produce significant heat during polymerisation. Medical grade cyanoacrylates by contrast, are typically n-butyl-ester, isobutyl ester, or octyl ester based and are specially prepared to cure with as little heat during polymerisation as possible. Excessive heat or rapid cure during polymerisation can lead to tissue necrosis.

Inside the body, these special medical grade cyanoacrylates are bacteriostatic, painless to apply when used as directed and eventually break down harmlessly in the tissue. Once cured, the cyanoacrylate is essentially inert. N-Butyl ester based surgical cyanoacrylates are rigid when dry, but provide a strong bond. Octyl products offer increased flexibility when dried, but reduced bond strength.

Bottom line is that the typical CA's used by woodturners are not made for wound repair. The heat generated during polymerisation may create additional damage to the wound area, which can lead to increased recovery time and scarring of the area. It sounds like you did the right thing getting your stitches and getting the wound cleaned up prior to closure. Take care and all the best to you and yours!

Steve Russell

EWW, WVP

The Woodlands, Texas

Re: CA Stitches - have you done it?

#7

Re: CA Stitches - have you done it?

john lucas

>When I did research on CA glues I had a huge stack of papers. There is a tremendous amount of information on the net. Steve just brought back all those memories of trying to decipher what they were saying.

As a rock climber I have closed many a wound with CA. We would just squirt some thin CA on and keep on climbing. Good stuff. Most of the time it worked perfectly, sometimes it would heat up quite hot, uncomfortable but not unbearable.

I think you did the right thing. Deep cuts should be looked at by someone who knows best what to do. Shallower cuts can easily be treated with the CA method. I will normally put pressure on the cut and then use a butterfly bandage until I can get the cut to stop bleading. Then I apply the CA so I can get back to work.

Re: CA Stitches - have you done it?

#8

Thanks Steve

Don Orr

>That was very interesting and informative. I thought I remembered there were different types but could not recall the details. Aren't the "Liquid Bandage" type products in the drug stores the correct medical type (butyl ester) CA. I have never tried either type but have heard of painful applications of the stuff we use in the shop.

Re: CA Stitches - have you done it?

#9

Ric Taylor

Re: CA Stitches - have you done it?

Ric Taylor

>CA was around a long time before the Vietnam conflict. The notion that is was developed during that time is an old wives tale.

CA that is used by medical professionals is a different formula than what we use in various hobby and day-to-day applications. The typical "store-bought" CA will work to hold a cut together, but it is not that same product that is used by doctors and nurses.

The medical variety is painless, which is not always the case with the more common varieties that we use.

Ric

Re: CA Stitches - have you done it?

#10

Re: Thanks Steve

Steve Russell

>Hello Don,

The formulas vary by manufacturer... IIRC, Bandaid Liquid bandage is formulated with a 2-Octyl Cyanoacrylate. 2-Octyl Cyanoacrylate's are better for minor cuts and scrapes (especially on the hands) because they are more flexible when cured than their N-

Butyl based cousins.

2-Octyl Cyanoacrylate is painless to apply (no heat!) and works very well. For me, it does not make sense to use an industrial CA for wound closure, when you can easily use the right medical grade CA's and eliminate all of the problems associated with using a product that is not designed to be used on your skin/wounds. Take care and all the best to you and yours!

Steve Russell

EWW, WVP

The Woodlands, Texas

Re: CA Stitches - have you done it?

#11

Thanks all, great info!!

Jim K in Trappe, PA

>

Re: CA Stitches - have you done it?

#12

Re: Thanks Again Steve

Don Orr

>Good info-I think I should have some on "hand". Three fingers on my left hand were in bandaids this weekend ;-(( Fortunately just little stuff.