Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Jet 1220 chip deflector

Posts

Jet 1220 chip deflector

#1

Jet 1220 chip deflector

GalenV

>Am I overly concerned or has anyone made a chip deflector to keep chips from pilling up on the Jet 1220 motor and eventually into the motor fan. The motor fan does not put out enough air flow to blow away the chips.

If someone has made up a chip deflector of some type I would be interested in seeing what you did. Not much space and maybe it just would be more of a trap to clean out.

Also has anyone made an extension to the light or relocated it on the bed. Seems the flex conduit will not let you move the light to show inside a bowl. Well, unless you put it low and upward and fill it with chips.

Thanks if you have comment on either item.

Galen

Re: Jet 1220 chip deflector

#2

Re: Jet 1220 chip deflector

Fog Tanner

>You might want to take a look at the Rikon deflector. It is a flat plate that is fastened to one of the webs on the lathe and keeps chips off the motor. It has a couple of "ears" on the side that are bent to fit within the lathe and crerate a "seal". A few of the Jet users in our club made deflector plates which looked like they fastened to the motor using existing screws.

They were having overheating problems when shavings would build up around the motor and the shields solved that. Theirs are curved to th contour of the motor.

I have the Rikon and the plate does keep the chips off the lathe. I also made a stand for it which has a hole that runs from under the motor and stops in front of the right hand feet. There is a chip chute the width of the opening that directs the chips out the back. With the bottom under the motor open there is no way for the shavings to pile up around the motor. This would probably work on a Jet with no heat shield.

Fog

Re: Jet 1220 chip deflector

#3

Re: Jet 1220 chip deflector

Lan Brady

>I hope I am not just misunderstanding. My 1220 came with a deflector from the factory!

Only problem, It sits high and the banjo nut hits it as I get close to the headstock.

But it keeps the chips off the motor fan.

Good Luck, Lan

Re: Jet 1220 chip deflector

#4

Re: Jet 1220 chip deflector

GalenV

>Lan:

Maybe your (92) motor dust cover, as the parts list calls it, is installed different than mine. The only time the banjo nut may hit mine is if it is set right over the fan shroud and I try to lift the motor too high to change the belt speed. Other than that the dust cover I have is mounted in full contact with the fan shroud and is flush with the fan shroud on the inboard end and maybe a fingers width overhang on the outboard curved end of the fan shroud. Chips pile up on top of the motor and since the motor fan puts out such a small volume of air they literaly block the fan shroud discharge and even fall back into fan. The chips cannot fall away to the side as the capacitor provides even more of a ledge for buildup. I use my shop vac to suck out the chips to keep turning as I can smell the chips on the motor getting hot. Mostly with bowl turning.

Shop vac is too noisy to keep the nozzle up between the bed to continually pick up chips. Just do not want the motor to overheat.

I guess I thought others may have same concern but maybe they have good chip removal system.