Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Question: Burning - Finishing Sequence

Posts

Question: Burning - Finishing Sequence

#1

Question: Burning - Finishing Sequence

Steve in NC

>Hi Folks

An artist friend of mine was in my shop a couple of weeks ago and mentioned that she had just purchased a high dollar wood burning tool. She asked if anyone burned bowls. I said yes and gave her a couple of links to explore. I also gave her several small bowls from my "rejects box" to play with.

Well, a week later she returned to most amazing artwork on the bowls, flowers, vines, geometric shapes... We deceided to try to collaborate on some finished pieces.

I tuned a couple of maple bowls this weekend and sanded them to 600. (they almost look waxed). The question is, do I give them to her with no finish and apply finish after burning. I an worried that if I finish them first the burning could be toxic. Also, the burning makes some rough edges, do I sand before finishing. Finally are there finishes that are better to use over the burning.

I am excited to give this a try. I will post results.

Thanks for your help

Steve

Re: Question: Burning - Finishing Sequence

#2

Re: Question: Burning - Finishing Sequence

Mike Jones, Redding, CA

>Applying a finish prior to burning will gum up the tip of the pen, as well as produce a stink. Take the sanding to 600 as you have done, then burn. Wipe the finished burning with DNA and this will take care of the fuzzies.

You can put just about any finish on top, but you don't want to do any more sanding than is absolutely necessary, so keep that in mind from the get-go. Sanding on top of the burning will invariably mess the design up.

Re: Question: Burning - Finishing Sequence

#3

Re: Question: Burning - Finishing Sequence

arkie

>If you sand after burning, you may smear the dark residue from the burning. You way want to experiment with a wash coat of shellac over the burning to seal that prior to sanding.

Re: Question: Burning - Finishing Sequence

#4

Re: Question: Burning - Finishing Sequence

Cyril Griesbach

>Steve, why not ask her what she thinks? I'm sure she has some past experiences with her wood burned pieces so she should be able to help you both come to a satisfactory answer.

Re: Question: Burning - Finishing Sequence

#5

Re: Question: Burning - Finishing Sequence

Ed Karch

>Burn before finishing. After burning use a stiff brush (not wire brush)to knock off excess char. I then use a grey abrasive pad lightly. I usually follow that with oil finish. use a light touch and you won't mess up the art work.

Re: Question: Burning - Finishing Sequence

#6

Re: Question: Burning - Finishing Sequence

Molly Winton

>The process I use is to burn, clean burned area with 91% rubbing alcohol (70% has more water, so can raise the grain), and then finish with whatever I would finish the piece with had there been no burning. I have yet to find any finish incompatable with burned designs.